southco electronic latch 3d models

Step 1: the only step is too carefully sketch out the part and precisely do the correct dimensions and boss extrudeStep 2: just be carful with some of the curves when using either arcs or circles

Plugs that can be used on the model, positioned using rubber bands.

CSWA part

Use for Door Cabinet....

I am a large language model. I don't have personal experiences or emotions like humans do. I was created to understand and respond to human input. ...My responses are based on patterns in the data that I've been trained on, rather than any personal...

The object shown was designed and created using Tinkercad. ...To make changes or view it online, visit this link: https://tinkercad.com/p/acc0fb94d216b2fd/21

cswa

Second try

Solidworks Certification test

step1: sketch geometry according to the blue prints (( !! crucial !! ...- when sketching make sure the arcs are fully defined first, then make the line under the whole cut out concentric with the axis))(note) the axis point in the blue prints can be...

I used the line tool to create my shape than started to dimension everything to the correct length. I used the arc tool so i could make my curves and everything. ...I than extruded than and but a circle on the shape and cut it through the entire shape.

This is an uncomplicated device designed to secure something in place. ...It's not exactly rocket science.

Simple FreeCad Assembly

I created this by measuring out the measurements on the front and extruding backwards.

I hacked out a shorter cut of that thing.

Steps:1. Started the sketch o the 40mm ark and dimensioned as I went, when I got to the corner with the two tangent arcs, I made the horizontal line coming from the 45 angle coincident with the point of the 29mm arc.2. Extruded to part width3.

Mass = 1066.52 gramsVolume = 135002.52 cubic millimetersSurface area = 18681.37 square millimetersProcedure: I started this model with the sketch from the front view. Started with the circle on the origin, then I sketched all the lines above and to...

Part of Obtaining SolidWorks Certification

Mass = 1066.52 gramsVolume = 135002.52 cubic millimetersSurface area = 18681.37 square millimetersFor 2D I used the line, fillet, and circular tool.For 3D I used the extrude feature.

Mass = 1067.90 gramsVolume = 135176.75 cubic millimetersSurface area = 18942.85 square millimeters______________________________________________________________________________________________________I started the sketch by making the general shape...

Tools used: Smart dimension, line tools, circle tool, trim entitiesMass: 1066.52

I simple just followed the blueprint instructions, dimensioned the figure correctly then extruded the figure to the correct measurement.

Mass = 1066.52 gramsVolume = 135002.52 cubic millimetersSurface area = 18681.37 square millimeters For creating this drew this out from the blueprint provide and started sketching at first the circle I did not put at the origin so make sure to do...

a tool

The material used is AISI 1020, and it has a mass of 1066.52 units.