south african vanagon grill 3d models
23923 3d models found related to south african vanagon grill.
thingiverse
While hardware is readily available, I did not find these parts when replacing a vent window frame in my 1984 Vanagon. This will be the same on several other Vanagons. ... This not only aligns the glass but would seem to isolate it from vibration and...
prusaprinters
These fit an '88 VW Vanagon 2WD (I don't have any other models to test it on). They don't have any clips on them, so glue or tape is all you need to get them to stick! One for the grille and one for the steering wheel. You may need to scale up or...
thingiverse
These fit an '88 VW Vanagon 2WD (I don't have any other models to test it on). They don't have any clips on them, so glue or tape is all you need to get them to stick! One for the grille and one for the steering wheel. You may need to scale up or...
thingiverse
Our Volkswagen Vanagon's fridge knob broke, but thanks to the Replicator 2 and a customizable knob generator, I printed a replacement after several iterations. The design was based on http://www.thingiverse.com/thing:55685, and was created with...
thingiverse
Table Knob for a Vanagon Westfalia table. Larger diameter fro a better grip and torque. Use a 10mm-1.50 X 50mm bolt available at the hardware stores. ...Use superglue to glue the cap on top of the body after inserting the bolt.
sketchfab
When you remove the rear heater core in a Vanagon Weekender, a gaping hole remains in the kick panel of the bench (rear seat) waiting to be concealed. ...This clever snap-in vent effectively covers that unsightly gap, eliminating any distractions from...
thingiverse
I crafted this clamp to fit snugly around the metal bleeder loop, specifically designed for the vanagon's rear section. Simply insert these clamps into the square ports located in the bay engine area and then attach the coolant loop, securing it with...
thingiverse
This replacement ceiling vent was designed this for a friend who recently purchased a 1988 VW Vanagon Weekender. This ceiling vent is designed to snap into place and have just the right amount of interference to prevent rattles and to provide enough...
thingiverse
These are the mounting fixtures for the Vanagon environmental control system components. You can source them from GoWesty or other suppliers, but I already had the bulbs and connectors on hand, which made this project more feasible, and it ended up...
thingiverse
It fits perfectly on my 1989 vanagon T3 westfalia and should also work well with other models. My settings for printing on my Anet A8 are as follows: Layer Height: 0.2mm Infill Density: 25% Infill Pattern: Cubic Print Speed: 60mm/s Support...
thingiverse
This thing holds your VW Vanagon rear hatch open. EDIT: This is an older revision and it has a blip at the very top. I'd recommend flipping the model upside down before printing. *WARNING*: use at your own risk. I would recommend using ABS or...