simmons surfboard 3d models

This is part of a set that includes the octopus tape dispenser and the flashdrive surfboard holder, all designed to work together as the ocean set. The concept of incorporating small tubules into this design served as an inspiration for a pencil...

The entire set comprises the body(Octopus) and the flash drive surfboard holder(http://www.thingiverse.com/thing:1965307). In this set...There is a small cylinder that holds the tape in the body. The small cylinder fits between the two notches in the...

I think the rear is further apart, but you'll figure it out quickly when you try to attach to base.Use M6x35mm screws and M6 washer to attach top-cross bar assembly to the base! Other Remarks:Printed with Carbon Fiber PETG.Infill at 40%Used with...

This Advanced Water Jet Drive is designed for large boats, kayaks, and surfboards. This high-performance jet drive can produce a flow rate of approximately 1000 liters per minute, provided you supply it with sufficient power. After several...

Spider-Bot from the movie Runaway (November-15-2020: Check out my new Lock-On Bot from the movie here also: https://www.thingiverse.com/thing:4654995 ) Hello all, over the last week I have been sinking all my time into this prop reproduction from the...

But it is also suitable for a huge RC boat and surfboard, for this purpose different configurations were made. it is also suitable for right and left rotation engines! The thrust of the water cannon from 22 kg to 28 kg, the thrust depends on what you...

This is a complete ecosystem of parts needed to place a small camera somewhere and fine adjust its orientation around all three degrees of rotational freedom. The problem: Using an action camera to capture our wild and crazy activities typically...

Props are not included (surfboard and ice cream) • Material ID Maps for Skin Eyes Hair Outfit Parts A Material ID map is used for changing the colors of a BaseMap separately. Use the included Material Instances to change the colors easily. • 4K...

To alleviate this problem, I added two large coreflute tails that extended below the plane a bit like twin keels on a surfboard. It looks pretty ugly but helps prevent damage to the motor mount and props that I was experiencing. However, what I...