shure sm57 90 degree 3d models

You need 2 x M4 bolt and print with support (extra support) No need to unweld SM57 very convenient for recording toms, snare ... ...and save space !

Mics that can be used Shure SM57 and SM58 Unidyne iii

I've added fastening for a shure sm57 (and similars) to the original model.

This is a prop of the popular Shure SM57 Microphone. This particular prop is good for testing microphone clips that will be used on the real deal. The dimensions are fairly accurate. This is the first design I've posted. Thanks for checking it out.

A tray that holds 4 Shure SM57 microphones so that they take up minimal space in the case drawer without flying around. It features a space for 19mm spike tape for labeling as well as slots to easily grab the mics.

This is a version of the print that can be glued together after it's printed. ...The full SM57 is too tall to print on the Printrbot Metal Simple.

This is a straightforward model featuring a Shure SM57 Microphone, and it comes complete with all necessary materials and textures. ...They can be found within the provided zip file for easy access and use.

This is a microphone holder for putting two Shure SM57s in a 45 degrees angle. It can be mounted on a normal mic clip. ...Be sure to check the measurements on the attached screenshots for scaling

This is a 55 degree microphone holder for the SM 57

This clamp is perfect for combining shure sm57 and other small diaphragm condenser mics and having them aligned. It is useful for hihats snares guitar amps recordings and much more!!! 

A little piece to adapt the notches to turn the mount of the SM7B 90 degrees, so that the output jack is oriented 90 degrees turned, because I had problems with the clearance with my boom arm but theres more than enough space on the "underside". ...

A little piece to adapt the notches to turn the mount of the SM7B 90 degrees, so that the output jack is oriented 90 degrees turned, because I had problems with the clearance with my boom arm but theres more than enough space on the "underside". In...

The model is highly accurate and based on the manufacturer's original dimensions and technical data.

The model is highly accurate and based on the manufacturer's original dimensions and technical data. This model is a high end, photorealistic 3D model, that will help you to add realism to your project. The model is suitable for any visual...

SHURE 57 90° ANGLE ADAPTER NO SOLDERING NEEDED PERFECT FOR DRUMS SET RECORDING JMC 3D

90 degree angle

Equal Tee 90 Degree

hook 90 degree

Stove pipe 90 degree

90-Degree clamp extension

90 degree bevel gear

Bracket 90 degree

90 Degree Joint

90-degree bevel gear

90 degree angle fixture

Clamp corner 90 degree angle

90 Degree Corner without holes

90 degree scaled measurement tools

90 degree pipe with threaded valve.

90 degree angle bracket, 30x30mm, L 50mm.