shell logo png 3d models

I used a light green for the stem and leaves, and red for the pot. All parts were printed with the following parameters: 0.2mm layer height 2 outline shells 3 base layers 3-5 top layers 5-15% rectilinear infill Servo Preparation This projects...

When there are different screws used, it will be mentioned! 1] Hinge assembly:Cut the head of four M4x30 screws off, so that the lentgh of the threaded part is 24mm.[red] Into every hinge-part you have to insert a M4 rod with a length of...

Connect the wires as shown in the wiring diagram:ArduinoStepper DriverStepper MotorD11EN D12DIR D13STEP 3V3VIO 5VVM GNDGND near VM  M2BDark Yellow M2APink M1ABright Yellow M1BBlueOptionally you can remove the small resistor besides the red pwr LED so...

Double sided tape work just fine but feel free to use a stronger adhesive DoneDummy moduleOne could use some corner brackets screwed into the Hex body walls and rest (or glue) a top lid on those to create a dummy module. I did not include such a...