scx10 pro transmission 3d models
94002 3d models found related to scx10 pro transmission.
myminifactory
Post mount front bumper for Axial SCX10-2/SCX10-3 vehicles. (2) light buckets for 5mm leds, compatable with Axial light bucket lenses (AX80045). ...Uses stock pin hardware for mounting and (1) M2x6 screw for the led retainer.
thingiverse
This is my innovative design, take it for a spin - it's a winner when paired with an RC4WD Bruiser body attached to an SCX10 chassis, and it'll also perform flawlessly on the upgraded SCX10.2.
thingiverse
Axial SCX10 Front Steering Link Bar V2 Enhanced for Improved Clearance and Travel.
cults3d
Rear body for trail honcho on SCX10 V1. ... Fit the cab and the fixation points.
thingiverse
Rear axle utilizing SCX10.1 knuckles, C-hubs, lockouts, and shafts, paired with 10.2 gearing.
thingiverse
Front Support Assembly Scaled Down For The Rubicon Body Of An Axial Scx10 Vehicle Now Completed.
thingiverse
I built my OSX10 using upgraded 1/10 crawler parts available at local hobby shops or eBay, along with the following prints: Bumpers & Mounts - Goodson's Hobbies - https://www.thingiverse.com/thing:3187821 https://www.thingiverse.com/thing:3008197...
thingiverse
Hi Guys, This is my second design for my Gen7 Pro, combining a SCX10 bumper mount and an internal spooled winch mount that allows use of an axle-mounted servo at full droop or spring compression to fit a Gen7 or Gen7 Pro. I haven't printed it yet...
thingiverse
Mounting plate for SCX10 transmission to mount 2 motor for more power at low speed
thingiverse
Attach an extension to lift your rock sliders back into position once you've elevated your SCX10.
thingiverse
Made custom body posts for my Axial SCX10, extending them beyond standard length to accommodate an aftermarket body.
thingiverse
All steel gear transmission and all steel driveshafts are used. The grill has two versions, one screw-on and another glue-on. The headlights take 5mm LED lights and you can glue in clear lenses that come from round LED pods. A panhard bar and servo...
thingiverse
I built my OSX10 using upgraded 1/10 crawler parts found at local hobby shops and eBay, along with several custom prints: * Bumpers & Mounts by Goodsons Hobbies (Thingiverse ID: 3187821 and 3008197) * Rear High Clearance Crossmember by Harley...