sandpaper organizer 3d models

122318 3d models found related to sandpaper organizer.

sandpaper holder
thingiverse

sandpaer holder for adhesive sandpaer 20mmx80mm

sandpaper handle
thingiverse

sandpaper box
thingiverse

sandpaper tray
thingiverse

Customized version of https://www.thingiverse.com/thing:3065794 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=3065794

Sandpaper support
thingiverse

Support for sanding tools is often provided by a sturdy grip.

Sandpaper holder
thingiverse

Size:20mm x 160mm x 5mm It has a curved surface and a plane.

Sandpaper holder
prusaprinters

Sandpaper Holder
thingiverse

This container cradles your sanding tool (since your sanding tool measures 100 by 235 by 10 millimeters). ...The original file is readily available, allowing you to make any alterations as desired.

Sandpaper Holder
youmagine

My setup consisted of a Prusa i3 MK3S rig. I worked with Prusament PETG material, layer height set at 0.15mm and infill density at 20%. Support structures were printed only on the print bed. ...The same material, Prusament PETG, was used throughout.

Sandpaper Dispenser
thingiverse

Sand paper dispenser. Ive made this for my work van. Rips paper off nicely. Printed in PETG, 0.28, 25% infill. For personal use or for printing for family and friends. ...Not for retail.

Sandpaper holder
thingiverse

I wasn't about to drop cash on a sanding block, so I came up with this two-part contraption instead. It gets the job done perfectly for my needs. ...To secure it in place, you'll need two M5 screws and two more M5 wingnuts to clamp it down tightly.

Sandpaper Dispenser
prusaprinters

Sand paper dispenser. Ive made this for my work van. Rips paper off nicely. Printed in PETG, 0.28, 25% infill. For personal use or for printing for family and friends. Not for retail. ...Print Settings Printer Brand: Creality Printer: Ender 5 Rafts: No...

Sandpaper Handle
thingiverse

Recommended print settings: Screw: build on layer 0.20, unsupported; Base: create at layer 0.20, standing vertically as shown, unsupported.

Sandpaper holder
thingiverse

You'll need to add some internal support if you want a solid base on the model, I recommend using approximately 20-30 percent internal reinforcement.

chopsticks sandpaper
thingiverse

It's a very simple tool in order to glue a small (1.5 cm circle/1.5cm square) on the top of a chopstick (the single-use ones are ok for this). I needed it to reach in and sand contacts inside a Solari Udine clock. ... Print on pla 0.2