s15 rc 3d models

These tires fit on the Traxxas X-Maxx, which I think is an awesome RC truck:https://traxxas.com/products/landing/x-maxx/If you want tires that last a reasonable duration, here are links to Traxxas tires that will last far...

The propeller is small, but it still uses a big RC aircraft motor. Whilst not sharp, the propeller blades can abrade through skin and clothing in seconds, and as such need to be treated with extreme caution when the motor is connected to a power...

Configuration for Ramps/mega/Marlin RC bug Fix from 21-01-17 on (it might work on earlier versions but you'll have to adapt the settings). Connect to Z_min endstop plug, ensure that signal,+,- go the right way, on the piezo board it goes +,sig,- on...

Therefore we assume a cylinder with the mass mc and the radius rc. Imaging the cylinder as a summation of multiple disks with the masses dm and the moment of inertia of (as calculated above):</p> <p>Integrating over all disks will give us the moment...

Some (better than mine) microsoldering skills are required, if you're using an SBUS receiver you need to run the RC jumper accordingly. WiFi network may be disabled permanently with following CLI commands: set pinio_config=1,1,1,1 set...

This is a redesign of markus_p's Mini FPV-Rover, modified to be controlled by a Raspberry Pi Zero W with camera, using the control software created by Wingman94 for it's ZeroBot Pro.Some changes from the original rover:Direct WiFi connection with the...

You will need a RC radio... I use a Jumper T16. It's 159.95$us at Team-BlackSheep.com. You will also need a pair of FPV googles... Mines are FatShark Attitude V5. 299.00$us at Team-BlackSheep.com. And finally, you will need SD cards to record...

I would have ordered this arm, but it it isn´t in stock in anywhere in our local RC-shops, so i have to wait until it re-stocks. - You also need these bearings for the steering arms: 4pcs of 5mm id, 8mm od, 2,5mm height. - And also 2 pcs of 3x7x3...