roundup shuttle 3d models
2901 3d models found related to roundup shuttle.
sketchfab
Here's a revamped take on the original text: This subpar short-range shuttle from the open-source Pioneer Space Simulator game leaves much to be desired. Its sluggish performance is further compounded by its low delta-V and mediocre maneuverability,...
thingiverse
Remix into Gekko concept shuttle "The Scythe" By Kevin Christley and Dom Pace Top cannon by https://www.thingiverse.com/thing:1872781 Lambda base by https://www.thingiverse.com/thing:4803389 Cargo pod by https://www.thingiverse.com/thing:4168050 SA 8...
cults3d
My stock Ender 3 v2 can not handle a 60 mm gap or bridging for the thread slot at the side of the shuttle so I had to use a tree support which I thought will provide the cleanest slot with minimal post processing like sanding the edges so the yarn...
thingiverse
This small rounded bobbin is specifically designed for a weaving shuttle, measuring 10.5 cm in length from end to end, or approximately 4-1/8 inches. It can be printed without supports, but requires a 90-degree rotation; a brim is highly recommended...
thingiverse
The shuttle is based on the Starmax design from Starcom, but with a few key changes. The front hatch needs to be shortened slightly to accommodate the new design. To keep it securely attached, holes have been drilled to fit 1/8-inch primal horizons...
grabcad
I crafted a CATIA model of a space shuttle as a fun project, including most details but no tiling textures or livery. To aid in accuracy, I used blueprints and various reference images, along with an earlier plastic scale model. While not 100%...
prusaprinters
This is a 4" (10 cm) bobbin for a Leclerc weaving shuttle. ...This prints just fine without supports, but you may want to add a brim to keep from toppling over.</p> <h3>Print instructions</h3><h3>Category: Replacement Parts Print Settings</h3>...
prusaprinters
A small rounded bobbin made for a weaving shuttle. It's 10.5 cm from end to end, or about 4-1/8 inches.</p> <p>Prints without supports (need to turn 90 degrees), brim recommended for bed adhesion. The cap is designed to press-fit onto the end of the...
prusaprinters
Once link you might need to put a small amount of glue to ensure the shuttle will not remain with a small gap. I made it two parts to fit in a typical printer. The bobbin we are using has a diameter of 22 mm and and height of 10 cm To hold the...
thingiverse
This is a model of the NASA Space Shuttle that can split into 4 parts with a stand. It includes the orbiter, the side booster (print two of these), and the external tank. The parts snap in and out very easily. This makes for a great desk model or...
pinshape
This versatile shuttle is fully modular and can be customized as a dropship, cargo ship, or even a small spaceship. Beyond just a deck plan, this product includes a comprehensive full-scale fuselage that's perfectly sized for 28mm miniatures,...
thingiverse
Here are the dimensions for this model when printed at 150% scale: Height: 107.5mm Width (bottom): approximately 70mm Width (main fuel tank): 12mm Booster diameter: 3.55mm Shuttle width: 24mm Engine diameter: 2.8mm Bridge gap between boosters: 12mm...
thingiverse
Designed by talented student Bryce F., this exceptional space shuttle model boasts functional cargo bay doors that can be opened and closed with ease. To assemble this masterpiece, 1.8 mm filament must be utilized to link parts where the holes align,...