romex clip 3d models
104754 3d models found related to romex clip.
thingiverse
Simple clip attaches Romex cable securely to the wall with ease. Made from PLA, ABS, PETG, Nylon, or other robust filaments, this clip is designed to provide a sturdy hold. ...Pre-drilled holes allow for quick attachment using thin nails or brads;...
thingiverse
I needed Romex 12-2 clips and I didn't feel like wasting 2+ hours in travel/laps around the home improvement store so I whipped up my own clip.
thingiverse
Needed a clip to hang wire/romex from the steel girders in my garage. I couldn't find anything that fit, so this was designed to be infill-free and easy to screw into steel. They were made to hold up to 2 1/2-inch cables with jackets. I'm sure it...
thingiverse
Romex wire holders with a smile. Used #6 drywall screws that were 1 5/8 inch long. This is for 12/2 with ground. Printed on an Ender 3 with 0.8mm nozzle. ...0.32 layer ht and 20% infill.
thingiverse
... And before anyone says it, YES you are allowed to put Romex (NM cable) in conduit, and its REQUIRED in areas where the wire needs to be protected. ... https://diy.stackexchange.com/questions/31149/can-romex-nm-b-cable-be-run-through-conduit
prusaprinters
Clamp/mount for fastening a NM electrical cable (Romex cable) to stud. Countersunk for an ANSI #8 82deg screw. Fits a 10/2 or 12/2 (10 gauge; 2 wire (excluding ground); 12 gauge 2 wire). ...Slot width: ½"W x .25"deep
thingiverse
I'm installing a garage heater and need some easy-to-install-and-remove wire staples for 8/2 Romex electrical wire, like Southwire's 8/2 8AWG with ground (available at...