refugium 3d models

This is designed to hold a 1/4" OD simi-rigid hose t0 the side of a rimless tank ie the sump/refugium. ...the gap is 5mm so it will slide over a wide range of thicknesses from 1/4" to 3/4".</p><p>I used it for the inlet line of my automatic water change...

This fixture holds a 1/4-inch OD hose on the side of a rimless tank, specifically in the sump or refugium area. The gap is 5mm, allowing it to fit over a wide range of thicknesses from 1/4 inch to 3/4 inch. ...I utilized this setup for the rigid line of...

The fluval flex had "non conventional" rear filtration chambers but I found out that chamber 2 can be a nice little refugium, thanks to *bayshield* (https://www.thingiverse.com/bayshield) for his work on the fluval EVO...

Remixed to accommodate a 1/2" ID (5/8" OD) tube for a refugium under a RedSea max nano. Had to create a 2nd version with the half-pipe curved support as the 1/2" tube was kinking with just a scaled up version of original file I was remixing. ...

... 1/2. Plus a complete version. Sizing may be off all around for chamber fit and may be too flimsy. Has not been printed yet. Also contains a totally separate redesigned version with one side open for potential refugium. ... In Development.

I wanted to put a chamber for Chaeto in my sump as a mini-refugium. Though I wanted to illuminate it from the side, gotta be different I guess. Ill check back with how it works. Resize to your needs in your slicer. ...I sliced this with Zero top and...

The link to the design is available below: https://www.thingiverse.com/thing:3313194 I trimmed the base to fit my refugium's dimensions and sealed the holes with silicone sealant, creating a sturdy foundation. The outer tube diameter measures 16.4...

Water passes down the centre of the tube hits the bottom and travels up the outside of the tube through the round base through the sand and out of the bottle and continues on its way through the refugium. ...The Fine floss in the bottle was the wife’s...

......The intended use includes holding a filter pad, providing a central hub for bio media or a refugium, and accommodating fluidized media like K2. To ensure durability, I plan to coat the entire structure with a waterproof material such as pond shield.