redarc bcdc1225d 3d models

DUAL INPUT 25A IN-VEHICLE DC BATTERY CHARGERBCDC1225DThe REDARC BCDC1225D In-vehicle Dual Battery Charger is a 12 volt, 25A in-vehicle DC-DC battery charger designed to charge your secondary battery banks to 100% state of charge while on the move.

This allows a Redarc brake controller knob to be mounted in place of the ECO button, for a nearly OEM look. ... I printed out of black ABS to handle the heat of a car interior.

I installed the RedArc brake controller in my Gen 2 Tacoma by cutting out a center console blank plate, but it wasn't an easy task. My brother-in-law then got the RedArc for his Gen 3 and since I had access to a 3D printer, I designed this part to...

60 amp fuse holder for BCDC1240 battery charger

If you want to mount the REDARC brake controller knob in your WL Grand Cherokee without cutting or drilling anything, then you need this! It mounts using any of the trim screws underneath your steering wheel. You simply need to route the Cat5 cable...

In a versatile vehicle battery charger, a robust multi-stage auxiliary DC-DC converter delivers reliable power at 12 volts and 40 amps.

I needed to install a Redarc trailer brake on my '19 Jeep Grand Cherokee (WK2) (Quadra-Trac 1) and did not want to drill a hole in the center console or dash panel for the remote adjuster. The center shifter console pulls up easily, and there is...

I tried to find a compatible insert to fit my car with a tow pro, but it wasn't available, so I created my own version.

The USB port that I used is just a cheap flush mount one from e-Bay, and the Brake Controller is a Redarc Tow Pro Elite. You need to print a Dash Tray and then the front that you want and glue them together. ... I've created 3 plates but only...