rc jetboat 3d models

Therefore we assume a cylinder with the mass mc and the radius rc. Imaging the cylinder as a summation of multiple disks with the masses dm and the moment of inertia of (as calculated above):</p> <p>Integrating over all disks will give us the moment...

If you know you need a centrifugal compressor but you need a ton of power for your application, you'd almost certainly be better off running with a model that was designed from the get-go for some kind of RC brushless motor (or another...

These tires fit on the Traxxas X-Maxx, which I think is an awesome RC truck:https://traxxas.com/products/landing/x-maxx/If you want tires that last a reasonable duration, here are links to Traxxas tires that will last far...

Update 22-07-17, so the Micro has finally got a z-probe, please see https://www.thingiverse.com/thing:2446460 now calibrating to 0.07mm deviation using RC's marlin and the Precision Piezo, Z-probe system. Update 11-07-17 Decided to try a new heater...

Some (better than mine) microsoldering skills are required, if you're using an SBUS receiver you need to run the RC jumper accordingly. WiFi network may be disabled permanently with following CLI commands: set pinio_config=1,1,1,1 set...

That one will be RC ready for electronics and covering, however it can not be scaled down like this one can. It's still a work in progress but the full wing has been posted for free for you guys to try and prototype. Check it out in my designs. V1...

Thinking of using Traxxas RC car components in m3 thread between the inner holes of the ribs. -I recommend always disinfecting the whole face covering before and after every use, eg with alcohol. But weather strip silicone D foam padding and...

This is a redesign of markus_p's Mini FPV-Rover, modified to be controlled by a Raspberry Pi Zero W with camera, using the control software created by Wingman94 for it's ZeroBot Pro.Some changes from the original rover:Direct WiFi connection with the...

You will need a RC radio... I use a Jumper T16. It's 159.95$us at Team-BlackSheep.com. You will also need a pair of FPV googles... Mines are FatShark Attitude V5. 299.00$us at Team-BlackSheep.com. And finally, you will need SD cards to record...

I would have ordered this arm, but it it isn´t in stock in anywhere in our local RC-shops, so i have to wait until it re-stocks. - You also need these bearings for the steering arms: 4pcs of 5mm id, 8mm od, 2,5mm height. - And also 2 pcs of 3x7x3...