rc glider fpv 3d models

Therefore we assume a cylinder with the mass mc and the radius rc. Imaging the cylinder as a summation of multiple disks with the masses dm and the moment of inertia of (as calculated above):</p> <p>Integrating over all disks will give us the moment...

Configuration for Ramps/mega/Marlin RC bug Fix from 21-01-17 on (it might work on earlier versions but you'll have to adapt the settings). Connect to Z_min endstop plug, ensure that signal,+,- go the right way, on the piezo board it goes +,sig,- on...

The propeller is small, but it still uses a big RC aircraft motor. Whilst not sharp, the propeller blades can abrade through skin and clothing in seconds, and as such need to be treated with extreme caution when the motor is connected to a power...

These tires fit on the Traxxas X-Maxx, which I think is an awesome RC truck:https://traxxas.com/products/landing/x-maxx/If you want tires that last a reasonable duration, here are links to Traxxas tires that will last far...

If you know you need a centrifugal compressor but you need a ton of power for your application, you'd almost certainly be better off running with a model that was designed from the get-go for some kind of RC brushless motor (or another...

A take on norwegiancreation's PID ball balancing seesaw using an Arduino.Video of this...

That one will be RC ready for electronics and covering, however it can not be scaled down like this one can. It's still a work in progress but the full wing has been posted for free for you guys to try and prototype. Check it out in my designs. V1...

Thinking of using Traxxas RC car components in m3 thread between the inner holes of the ribs. -I recommend always disinfecting the whole face covering before and after every use, eg with alcohol. But weather strip silicone D foam padding and...

Update 22-07-17, so the Micro has finally got a z-probe, please see https://www.thingiverse.com/thing:2446460 now calibrating to 0.07mm deviation using RC's marlin and the Precision Piezo, Z-probe system. Update 11-07-17 Decided to try a new heater...

Redesigned the HDMI screen bezel to use a FPV HDMI extension and one of the Raspberry Pi HDMI backpack connectors. This will double the cable back into the space made in the cover. #It's thick! By design the whole thing is pretty thick. Not much...

I would have ordered this arm, but it it isn´t in stock in anywhere in our local RC-shops, so i have to wait until it re-stocks. - You also need these bearings for the steering arms: 4pcs of 5mm id, 8mm od, 2,5mm height. - And also 2 pcs of 3x7x3...