rc bumper 3d models
41696 3d models found related to rc bumper.
thingiverse
The factory front bumper is mounted directly to the rear. ...Two models are available, featuring either a 3mm or a 5mm drop.
thingiverse
I'm planning to design a custom bumper for my Arrma Typhon RC car. The new bumper was successfully tested on the model instead of the original one and works perfectly fine. With 100% infill, it has enough strength to handle everyday crashes without...
thingiverse
Dies ist ein RC Frachtschiff mit einer länge von 43 Cm und einer Höhe von 13,8 CM es ist gut für den Einstieg gedacht/This is an RC cargo ship with a length of 43 cm and a height of 13,8 CM it's well designed to get you started
thingiverse
Front bumper mount could probably be used for other than just the IERC bumpers with minimal effort. Rear bumper has a spot to mount a DSM Integrated Recovery System pulley, all tucked up and neat. I suggest a spacer (2mm or more) between the pulley...
thingiverse
A bumper for a rc car. Made one cause the stock one broke. I printed in ABS as it is stronger and did 30% infill you can make it higher if you need it even stronger. ...Print face down to use minimal supports.
thingiverse
After 30 years it becomes more and more difficult to get a spare parts for my Tamiya Bullhead RC monster truck. Here my approach to print the bumper and glue a self sticky silver foil on top. Looks not too bad and is more stable than the original...
thingiverse
Just whipped up a quick front bumper for my Axial Wraith, figured I'd share it in case someone needed one. ...Thanks! P.S. If you need these printed or are into all things RC, check out my FB page: https://www.facebook.com/BYRCSpeedway/