razer junglecat s10 3d models

My work shop is embarrassingly messy at the moment but I have tested them and they seem to work as intended. Print instructionsThe parts were designed to not need supports you will need to use a knife, razer blade and/or deburring tool to cut out the...

I was tired of the lack of an analog stick for movement on my Razer Blackwidow V3 mini. unfortunately, I was not able to easily find the joystick used in the original design, so I redesigned mine to use the common PS2 joysticks found on amazon like...

its also why temp is so high. I used a 0.6mm profile as a starting point and scaled all the settings for 0.8mm nozzle. 0.8mm nozzle, recommend tuning extrusion multiplier, mine is set to 1.08 retraction for 0.8mm nozzle was set to 0.4mm Extrusion...

I designed the path just wide enough to squeeze a piece of bowden tube in, and then trimmed the inside with a razer blade, so the filament will have a narrow path and just enough was cut away for the encoder to press against it. The cable that...

max size Hardware 24x 608ZZ - 8x22x7mm Ball Bearings (standard skateboard bearings)12x M6 70mm Hex bolt12x M6 Nut8x M3 10mm screw (for the motors)2x velcro strap for holding batteriesElectronicsAny RC radio and receiver with 2 PWM outputs2x 4010 12v...

Please note, this is a 0.15mm nozzle print!!! komplett3x3_3RUT_S10_xy0.15mm_z0.1113mm_PLA-PHA_PLA-PHA_PLA-PHA_PLA-PHA_PLA-PHA.3mf I used PLA (two materials, black and white in my case) for the print. Large rocket (150 hours, 2011g of filament)Please...

M280 P0 S10 ; Deploy the probe 7. G91 ; Set Relative Positioning 8. Slowly lower the nozzle with G1 Z-1 or G1 Z-0.1 or G1 Z-0.02 until the sensor is triggered. NOT FURTHER! 9. If the sensor has triggered and flashes: M280 P0 S160 10. M114 ;=...

I use a chisel or razer to chip off any of the excess that isn't fully adhered and then any of the stuck-on excess I use a palm sander to sand down flush with the surface. At this point you have a functional guitar body. If you want to go further and...

Once vanished, use a plastic model razer saw or a flush cut saw to cut the parts away from their rafts as close to the raft as possible. This should leave you with a mounting flange. Glue the bell sections together using standard model airplane glue...