quantuman xc3 xada 3d models

EVGA XC3 3090 Graphics Card with an EK Vector waterblock on it. ...Modelled in AutoCAD and exported to IGES

I decided to take a shot at 3d modeling and printing trim cover for my evga xc3 3080 (but also works on 3070/3090 xc3) until evga has an official replacement. I had a little bit of a learning curve with fusion 360 but after watching a few videos I...

3rd version of my EVGA RTX 3060 Ti FTW3 / 3080 XC3 / 3090 XC3 shroud. ...This shourd might work for other models as well, as long as the fans are 120mm.

PLC model design

I designed this shroud to fit the standard EVGA XC3 cooling block and fit 2x 120mm standard case fans for better cooling and noise performance. the shroud is designed to fit Noctua NF-S12A FLX Fans but could probably use any other 120mm fans. The...

I remixed the design since the Ender 3 has a smaller bed and I wanted to print with the fan side facing down. Split down the center and each piece fits a 120mm fan and a gap in between to run the fan cables. ... Photo with fans installed:...

Advanced decoration of my EVGA shroud.

Needed a GPU support for my EVGA GTX 3070 XC3. ...(90mm)

... accent piece. Tested on FTW3 only, because of the size difference it will not work with XC3 variants. Should work with RTX 3070 FTW3 as well. ... To install, line up and press down both ends of the cover, the centre piece should pop into place.

Rough draft of the Kevesi Power Frame disc seen on many costumes in XC3! ...This one is theoretically scaled to the size seen on Eunie and Riku's belt, but could be shrunk down to fit the smaller ones seen elsewhere.

Tested on FTW3 only, because of the size difference it will not work with XC3 variants. Should work with RTX 3070 FTW3 as well. To install, line up and press down both ends of the cover, the centre piece should pop into place. Print Settings Printer...

I installed this support bracket in the Cooler Master NR200P case on top of an Arctic P12 fan to support an EVGA RTX 3080 XC3. The GPU is more towards the back of the fans, therefore the fan/airflow clearance curve is off-center. The bracket plugs...

Tested on FTW3 only, because of the size difference it will not work with XC3 variants. Should work with RTX 3070 FTW3 as well. To install, line up and press down both ends of the cover, the centre piece should pop into place. Print Settings Printer...

... GPU as it would be normally mounted. The full set includes a blank front section, but I have included a "FTW3" and "XC3" front section for both the right and left mount brackets total height added is just over 1.25in Tips are greatly appreciated!

... a little bigger, and centered better. Note: It might work for all the EVGA RTX 30 series FTW. Will probably not work for XC3 series though. ... Guide can be found at: https://forums.evga.com/EVGA-RTX-3080-Ti-FTW-custom-fans-guide-m3502802.aspx

An updated version (XC3.6) is available with additional material to prevent warping and added mounting points for quick fit extruder hardware. To print the necessary parts, create four bearing holders, one carriage, and two belt clamps, ensuring your...