pocket puss 3d models

I then un-triangulated the whole thing to make it easier to work on, created pockets for the two bearings, and so on.I then added an extension for the motor, with the two aligned to place a 0.15mm gap between the two sets of gear teeth.Finally, I...

As you might have guessed by the file names, this is not my first attempt :) The previous clocks used a chain rather than clock cord, and I gave up trying to get my pocket chain wheel reliable for heavier weights. ...This is the first prototype using...

Two 1/4"-20 hex nuts need to be inserted during the print, so add a colour change at the top of each of the two nut pockets (20.8mm and 21.8mm). The printer will stop during printing at these points and ask for a filament swap, you can insert the...

Spring Steel Sheet with Smooth Double-sided PEI before printing with PETG filament.Water: WaterCleaning Agent: 2-Hexoxyethanol, Isopropanolamine, Ammonium HydroxideWetting Agent: Lauryl Dimethyl Amine Oxide, Sodium Dodecylbenzene SulfonateFragrance:...

(Note that the bar in the pics has unneeded holes drilled in it - this is an older bar I had around)Insert two m3 hex nuts into the two pocket holes in the Central Arch (there is one in the back and one on the right side).  Do not force the nut in...

I took a fifty-franc note from my pocket, put it in the envelope, sealed it, and handed it to the patronne. "If the girl I came with asks for me, will you give her this?" I said. "If she goes out with one of those gentlemen, will you save this for...