pegboard keyhole 3d models

I have old pegboard in my garage, where the holes are only 3/16 inch diameter, and the board is 4mm thick. I remixed the original design (meant for the new 9/32 pegboard) using pegs generated by https://www.thingiverse.com/thing:537516 I used a 3/8...

... were made to suit slightly smaller openings. ...Following printouts, I observed that the lower hooks' vertical dimensions were too big to fit onto my pegboard. ...The bevel on top of each lower hook was carefully removed, resulting in a perfect fit.

This is a ground-up redesign of GA_3D's design, tailored specifically for 1/8 inch thickness pegboard, which can be found here: http://www.thingiverse.com/thing:559094. The original design I printed from PLA, and even though it was too short,...

I designed a pegboard shelf to accommodate my tape measure perfectly - after printing it out, I noticed an abundance of excess material in the model that I could improve upon - I've since created a second iteration called tapeholderthin, which...

Works in round holed pegboard Category: Organization

Hold Incra Protractor to 1/4 pegboard.

Plier holder for metal pegboards

a pegboard mounted organizer for screwdrivers.

This is a pegboard knife display

A holder for bits on pegboard

Pegboard tape holder. ... Requires no supports.

Mica Pegboard Holder for containers < 36mm

Two pegboards hold wires securely in place.

Testers Rely on Paint Pegboard Organizer

Works in round holed pegboard Category: Organization

goes into pegboard for running cables

Simple remix to include pegboard plugs

this is a wire stripper pegboard holder

Handy Dandy Pegboard Adhesive Dispenser Rack

Pegboard holder for chemical wash bottle.

Remix for battery holder for pegboard

Pegboard mounts for Nintendo handheld consoles

This is a big shelf for pegboard

76mm diameter cupholder meant for IKEA pegboard

Pegboard mount display for Gameboy Advance

For 15mm Grid Pegboards Featuring 4mm Holes

Gundam Wall mount for my Pegboard

Echo dot gen 3 pegboard holder

Credit to @brnhx_289665 for the pegboard peg model which is used here (also to @ScruffyOrc_217627 for this model, though I didn't end up using it).The model was made in OpenSCAD and is lightly parameterized to support other keyhole distances, so this...

Pegboard accessories for booth.Designed for DAISO's pegboards: 沖孔網板/30x40cm