nwt 20 3d models
198102 3d models found related to nwt 20.
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the following options: motor_shaft = 4 m3_dia = 3.2 pulley_b_ht = 0 no_of_nuts = 1 additional_tooth_width = 0.2 idler_ht = 2.5 nut_angle = 90 teeth = 20 profile = 6...
prusaprinters
A simple ruler of 20 cm long. Print instructions2 colours: 1 for the ruler and 1 for the numbers obtained with filament change. I added a name and a drawing (both extruded) for the one I printed.
sketchfab
The high-precision PBSS Series offers a spline size of .787 inches and a shaft diameter of 20. This is achieved through a unique combination of advanced materials and precise manufacturing processes. ...The result is a reliable and long-lasting...
thingiverse
A Simple Spool Holder for Any Printer with a 20/20 Aluminium Extrusion Frame Requires Minimal Materials. A M8 Bolt at Least 30 mm Long, Alongside Two M8 Nuts and One 608 Bearing Are Essential Components. This Design Does Not Incorporate a Filament...
cults3d
Just a simple spool holder for any printer with a 20/20 aluminium extrusion frame. You'll need a M8 bolt at least 30 mm long, a couple of M8 nuts and a 608 bearing. It does not have a filament retainer, but I didn't find it to be a problem. There's...
thingiverse
I have experimented with these prints, discovering that a layer thickness of 0.15 mm provides optimal strength.\nPrint Settings\nPrinter Brand:\n MakerBot\n \n Printer:\n MakerBot Replicator 2X\n \n Rafts:\n No\n \n Supports:\n No\n \n Resolution:\n...
grabcad
A 20-litre container holds contents, unfitted with a valve for liquid passage. ...With the bottle filled to its full capacity of approximately four cubic meters, the container measures around 96 centimeters tall and boasts a diameter of about twenty...
pinshape
Designed specifically for mounting on T-Slot type extrusions such as Misumi, 80/20, OpenBuilds, etc., this housing features a 30° tilt for enhanced accessibility post-mounting on the printer. The snug fit ensures a mere 0.1 mm clearance all around...
thingiverse
This mounting device is specifically designed for attachment to a T-Slot type of extrusion, such as Misumi, 80/20, or OpenBuilds. It boasts an adjustable angle tilt of up to 30 degrees, allowing easier access after mounting the printer. Its precise...