nr200 dual radiator 3d models
55837 3d models found related to nr200 dual radiator.thingiverse
This custom bracket facilitates a top mount slim radiator in the CoolerMaster NR200. This allows the top panel to be removed with a radiator installed, making maintenance of custom water-cooling easier. ... Combine with top panel...
thingiverse
... the SolidWorks part file if you would like to edit it. The parts were printed in PLA and haven't had an issue with it falling (yet lol). Pic: https://prnt.sc/aNHpOBZYbDTd More info: https://www.reddit.com/r/sffpc/comments/ztpnev/diy_nr200_max/
thingiverse
Cut out top panel to fit a slim radiator in the CoolerMaster NR200 when combined with custom radiator brackets (https://www.thingiverse.com/thing:4837035 , https://www.thingiverse.com/thing:4837043)
thingiverse
Coolermaster NR200 bottom Feet with Fan/Radiator shroud for those who want to install there Fans/Radiator underneath there case. Fan 25mm, Radiator 28mm, 38mm, 45mm & 60mm for those after after the thickest Radiators. this is a similar design to that...
thingiverse
Hier ist ein Radiator Halter für das Cooler Master NR200/P Computergehäuse. Der Halter ersetzt das Originale Blech welches leider ein paar Millimeter zu schmal für einen Alphacool 280mm Radiator ist. Mein Design ist an das "Cooler Master NR200...
prusaprinters
Summary of the T240R- Top 240 mm Radiator mount for the Coolermaster NR200 ITX case.This is a mounting assembly/system mod for the Coolermaster NR200 to mount a full size 240mm radiator with 2 120mm fans to the top of the NR200. This mod uses the...
thingiverse
Dual 120mm fan front panel for NR200, the bottom one helps with GPU temp a lot. The top one is useful if the psu is mounted at the front, and I would recommend cutting a section of the front wall of to expose the entire psu fan. The clip is...
thingiverse
A custom designed mountain bracket for fitting two 3.5" HDDs on the side mount of the Cooler Master NR200 (or NR200P) instead of one. The bracket attaches using the included #6-32 case screws and will work with all standard 3.5" drives. The mount...
thingiverse
if there is not enough space for a side mounted radiator above the fittings of the horizontal installed watercooled graphic card you will need do shift the side bracket upward. just print these 2 brackets. original screws should fit. ... the gcode...
grabcad
Dual-flow two-pass radiator designed for a 1970 Chevrolet Camaro. ...Typical square fins with a single S-curve fan.
cults3d
This radiator features dual electric fans and was designed as a drop-in for the Revell '57 Chevy Bel Air kit, along with other related models (Del Ray, Nomad, etc.), but could also be used in a variety of other applications. ...This is an ideal upgrade...