nlr logo 3d models
85122 3d models found related to nlr logo.
thingiverse
This is a cup holder for the NLR F-GT, sizing of the attachment are 42x42x42 instead of 40x40x40 for the reason of being able to attach it quickly and have an option to move it to your liking and also be able to double sided tape it in the future. ...
thingiverse
Hey, Check out this brand new, super easy printable quadcopter frame! It's designed for lightweight performance, strength and loads of fun. The frame measures 250mm in size and weighs a mere 170 grams. Currently, the frame is built for flying...
thingiverse
I printed it in PLA and TPU, but PLA breaks easily. ... TPU is more durable and the landing is much better because of the rubber effekt ;) Probably Nylon would be the best, but i didnt test it yet.
thingiverse
I made a handbrake holder for the F-GT formula position. It may need some tweaks so if anyone wants to do a remix you are more than welcome, but for me this works fine on my rig. ... Printed with 50% infill and tree supports.
thingiverse
Small mounting solution for power panel allowing to mount power strips, usb hubs, wheel power supply, etc. ...For mounting I have used M6x40 screws and 10mm nuts.
cgtrader
The Metroliner model is highly detailed and close to its original scale. It features fully textured design, animateable components like propellers, flaps, ailerons, rudder, and elevators, and a cabin with seating, deck bulkheads, and walls that are...
cgtrader
Metroliner is built very near to scale. The model is fully textured. It comes with a detailed cabin seating, cabin deck bulkheads and walls, interior detail so that it might be seen from an exterior camera shot. SA226 here is stretched version. ...Model...
thingiverse
I made a handbrake holder for the Next level racing F-GT formula position. It may need a remix to clean it up if someone wants to do it, but for me it works well on my rig. ... Printed with 50% infill and tree supports.
thingiverse
A simple mount for transducers on the back of the seat for the Next level racing f-gt Printed with 50% infill I used a m6 screw and nut.
thingiverse
A simple solution to mount a bass shaker to Next Level Racing F-GT rig withou the need of drilling any holes. ... More details in the video: https://youtu.be/al3gEAN6RiI Requires 4x 60mm M8 bolts and 4x M8 Nuts.
prusaprinters
<p>Hardware needed:<br>1x M4x20<br>2x M4x12<br>3x M4 Nuts<br>Velcro <br><br>Glue/Stick a bit of velcro to the keyboard holder and back of the keyboard so you can remove the keyboard if needed.<br><br>Adjust the angle of the holder and tighten...