mini latch 3d models

Steps:1. Started the sketch o the 40mm ark and dimensioned as I went, when I got to the corner with the two tangent arcs, I made the horizontal line coming from the 45 angle coincident with the point of the 29mm arc.2. Extruded to part width3.

The object shown was designed and created using Tinkercad. ...To make changes or view it online, visit this link: https://tinkercad.com/p/acc0fb94d216b2fd/21

Mass = 1066.52 gramsVolume = 135002.52 cubic millimetersSurface area = 18681.37 square millimeters Process:I sketched the whole part in just 1 sketch and then did the boss extrude. ...It was relatively easy it's just figuring out the dimensions.

Part was built :)

Use for Door Cabinet....

Mass = 1066.52 gramsMake a sketch with a circle at the origin R6. Make a line to the left and underneath both 14 away. Make the left line 18 and between those a 45degree angle line. The bottom line running until a R5 circle's top. From that circles...

Plugs that can be used on the model, positioned using rubber bands.

The material used is AISI 1020, and it has a mass of 1066.52 units.

I created this by measuring out the measurements on the front and extruding backwards.

<p>PLA 200/60</p><p>Fan 100%</p><p>no supports</p>

This is an easy-to-use, straightforward equipment that simplifies tasks and enhances performance. ...Its user-friendly design ensures hassle-free operation, making it perfect for those who prefer a no-nonsense approach to hardware.

I started by sketching out the front profile, making sure all the measurements including radius' were correct, then I boss extruded the model without including the circle.

step1: sketch geometry according to the blue prints (( !! crucial !! ...- when sketching make sure the arcs are fully defined first, then make the line under the whole cut out concentric with the axis))(note) the axis point in the blue prints can be...

Second try

First, I started by sketching out the outline of the front view of the sketch. I used the dimensions in the blueprint to sketch out guidelines for me to use to sketch it out. I used the line tool and the center line tool the most in this project.

CSWA part

I started by sketching out all of the straight lines and dimensioning them as such. To create the curved geometry, I used two different types of arcs. I created a centerpoint arc, using the midpoint of the long line in the bottom right as the center....

a tool

CSWA part

Use for Door Cabinet....

I started by sketching out all of the straight lines and dimensioning them as such. To create the curved geometry, I used two different types of arcs. I created a centerpoint arc, using the midpoint of the long line in the bottom right as the center....

This is an uncomplicated device designed to secure something in place. ...It's not exactly rocket science.

school education

Test prep project