meshlicious 3d models

Edit: 2022-03-28: Created a v2 that's a bit thicker and has an additional passthrough for a GX16 connector. It turns out this last connector is actually in the way of the PCIe horizontal bar, and should be raised about 10-15mm or so before printing,...

<p>Edit: 2022-03-28:</p> <p>Created a v2 that's a bit thicker and has an additional passthrough for a GX16 connector. It turns out this last connector is actually in the way of the PCIe horizontal bar, and should be raised about 10-15mm or so before...

Designed to fit 2 60mm fans on the rear of the ssupd meshlicious

Custom Bracket to install the network card in the SSUPD Meshlicious using a PCIe M.2 Extension next to a waterblock'ed GPU

I designed this to mount a EKWB FLT 120 reservoir/pump inside a SSUPD Meshlicious ITX case. I needed a versatile and space-saving modular system. ... Fastening hardware not included.

This dual-fan bracket was used in my SSUPD Meshlicious build. ...It was zip-tied though the bracket with the loops through the heatsink of a Zotac 1080ti Amp that was deshrouded.

After the 20mm standoff mod in my Meshlicious case, the GPU cover for the Galahad no longer fit under the panel. Here's a mod to lower it a little over 5 mm. I printed the diffuser in inland luminous which does a pretty good job diffusing the light...