masterbox q300l ssd mount

MK3S+/Y-axis belt tensioner
prusaprinters

How to install it in the printer?● insert the first M3x8 screw from the outside into the upper hole in the front board ofthe printer intended for mounting the original return pulley bracket (CAUTION - theoriginal M3x10 screws must be shortened by 2...

The Seven Zhanded Sun Swords of the Soulfire Phoenix
thingiverse

However, most surprising of all were the thousands of tiny muislings, who upon seeing the flag of the Tharch of the Western Pridelands, which consisted of a muisling mounted on an al-mi'raj aiming a spear at the open mouth of a tampant snake, took a...

Ultralight Endfed Triband Half-Wave Antenna
thingiverse

Finally, mount the caps to the tube with superglue. Since this is irreversible and you cannot re-insert the antenna wire afterwards, make sure they are in place and can't slip out. Solder the antenna wire to the AWG26 and secure the loose cables...

Buratinu Maxi 1600
thingiverse

I changed the motor and mounted an Extron 2217/16 (KV 1140, 28 mm diameter and 33 mm length) on a 9" x 6" folding propeller. It draws 22 amps on the 3S/1000 battery when stationary. This makes for an exceptionally good motorization. The elevator...

Dumbo 9000
thingiverse

As of 09/16/2018, I've printed the servo brackets and mounted them onto a wooden platform (shelf from Home Depot). I've printed 15 knuckles and assembled them with nails. I purchased some hardened steel cutters to cut the nails into short segments...

TTP-223 range extender
prusaprinters

The whole assembly is then mounted to bed headboard with 2 strips of double sided tape. Print Settings Printer Brand: Prusa Printer: I3 MK3S Rafts: No Supports: No Resolution: 0.10 mm Infill: 15% Filament: kexcelled PETG White Custom Section...

Magnet Wire Measurer
thingiverse

It is in the public domain.*/ // this constant won't change: const int buttonPin = 2; // the pin that the pushbutton is attached to const float unitsPerRotation = 0.31145; // feet per rotation // experimental measurement for calibration: 3.7375...

Five33 Tiny Trainer 3" v2 DJI O3 conversion canopy
thingiverse

With a strategic vertical mounting of the air unit on the canopy's rear, accessing the Flight Controller is as simple as ever. Two screws are all it takes to lift the canopy top, granting you unhindered access for tuning and adjustments. ##...

Bosch Rotak 32R Lawnmower Pulley/Fan - Version 2.3
thingiverse

Going forward, the new model uses an interference fit on the fan with provision for tapped holes to mount the pulley. I also made some adjustments - including a protection ring around the blades of the fan to avoid them flying off when it makes...

Modular Storage-System for Ikea Skadis
thingiverse

Uploaded a slightly improved Version of the “Connector” which connects two “base_drawer_153x45x20” Improved fitting and mounting ---------------------------------------------------------------------------------------------------------------- UPDATE...

Rotary Axis for Laser Engraver
thingiverse

Just in case, a link to the project and in the same place links to its modifications - https://go.like-it.link/ESOmq To use this rig, the laser engraver must be mounted much higher than it is used for flat surfaces. For example, you can cut cubes...

Cyclone Motor Upgrade
thingiverse