magjig 150 3d models
21433 3d models found related to magjig 150.
thingiverse
I made drewMarkForged's design bigger and added holes for the Magswitch MagJig 150 magnets. **On my Ender 5 I needed to turn the part diagonally ... ...Depending on your printer it might be easier to fit without a skirt.
prusaprinters
This base holds 2 Magswitch 150 clamps, and is designed to attach to the Magswitch universal track, which can act as a fence, hold clamps, hold-downs, featherboards, etc. The mounting hardware in the photo is included with the universal track; I...
thingiverse
This jig holder is for the Magswitch MagJig 150, based off of ShawnGano's design for the MagJig 95. ... The MagJig 150 fits nice and snugly into the hole, but it is still easy to pop it out by pushing from the bottom.
thingiverse
Dial Indicator mount for the Magswitch MagJig 150
thingiverse
I made it bigger and added perfect fitting slots for the Magswitch MagJig 150 magnets.
thingiverse
I made a single MagJig150 magnet base to go with raysfix's arm and divided his arm into individual parts to make it easier to print. Double MagJig150 version available here: https://www.thingiverse.com/thing:5330397 be sure to check out...
thingiverse
I made a double MagJig150 magnet base to go with raysfix's arm and divided his arm into individual parts to make it easier to print. Single MagJig150 version available here: https://www.thingiverse.com/thing:5330319 Be sure to check out...
thingiverse
A jig for the Magswitch MagJig 150 switched magnets... I had designed it to try out as a thin-rip jig for the table saw, but it has proved to be useful on the bandsaw, the scroll saw and the drill press as well! The Magjigs are a perfect fit and...
thingiverse
- 3 top and bottom layers - 4 perimeters (for extra strength) - 25% infill - I used PETG as my garage gets quite hot in the summer Mounting Hardware: - To mount the holder to a jig (plywood in my case) I used #8 screws (4mm) - To mount the MagSwitch...
thingiverse
To assemble it, follow these instructions: You will need the following settings: Wall thickness (w1): .4 Layer height: 150 Draft angle (D): 58 degrees Retraction speed (R): 6.2 mm/s Heated bed temperature: 100°C To use the automatic filament...
thingiverse
Thingiverse URL: thing:62800 Instructions: Using the following settings: gopro_captive_rod_id is set to 3.8 gopro_bar_screw_nut_d is set to 6.01 gopro_bar_rod_d is set to 31 gopro_rod_nut_th is set to 3.6 gopro_captive_protruding_h is set to 0.5...
thingiverse
Customized version of https://www.thingiverse.com/thing:619626 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=619626
thingiverse
Customized version of https://www.thingiverse.com/thing:4510064 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=4510064
thingiverse
Customized version of https://www.thingiverse.com/thing:2280529 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=2280529