macbook pro replacement key 3d models
372206 3d models found related to macbook pro replacement key.
thingiverse
... a new one to substitute the old one. ...This replacement key doesn't utilize the spring system (I also shattered this while attempting to reinstall the original key), instead, it simply rests atop the actuator and functions as expected when pressed.
thingiverse
You're in need of a brand new MacBook keyboard replacement. ...According to the instructions, this one is specifically designed for the F-key location.
thingiverse
This is a replacement keycap for the small key for a macbook pro early 2011 model. Might work in other models, but I have not tested it. It is meant to be used without a rubber pad in-between (I have lost mine as well). If you still have the rubber...
prusaprinters
My old 13inch MacBook pro started loosing it's feet. This model can be used to print a replacement with flex or PLA fillament which you can then glue in place. Note: depending on which of the 4 corner you print for you might have to cut off a bit of...
thingiverse
The original MacBook Pro rubber feet were lost; thus, replacement feet are required for printing, with four needed in total. Installing them involved removing the back cover and gluing in position. To enhance security, a soldering iron was employed...
thingiverse
Replacement Foot for MacBook Pro Retina. A swift Tinkercad remix of Goananndan's design with an added lip, eliminating the need for glue. I've been using one of these replacement feet for six months now, and it still performs admirably. Although...
thingiverse
Replacement key cap for MacBook Pro 2020 - 2021 (and later?) only !! Works for "Magic Keyboard". This is a letter key, other symbols might not have the same size / clips. Make sure to print with a 0.25 nozzle or smaller. Supports are required...
grabcad
Revolving around powerful performance, the MacBook Pro is a high-end laptop manufactured by Apple. It boasts an impressive range of features including a Retina display, Touch Bar, and Touch ID technology, making it an ideal choice for professionals...
thingiverse
I designed an exact replica of the MacBook in Autodesk Inventor, infusing every detail to make it look authentic. The 3D print turned out fantastic, and now it's a stylish addition to my workspace. ...I strongly suggest printing this model upright, just...
thingiverse
It's a stand, for a MacBook / MacBook Pro built between 2009 and 2012!
thingiverse
Replacement MacBook Case Feet are now available. ...The corresponding STL file is attached and ready to use.