m12 belt sander

sander rood
thingiverse

... are [3,6,4,8,4,7,3]. Loop_x_position has been set to 9. Text input is Sander. Rotation angle is 50 degrees. Center alignment is enabled at 60 percent. Loop_font chosen is Chewy. Loop_character entered is the letter "u". ... twist factor is -3.

Disc sander
thingiverse

Disc sander with drill. Need an angle grinder disc, drill adapter and bolts M6x30 3 pcs. The drill must rotate in the correct direction (not reverse) to prevent the adapter from unscrewing from the disc. Disc must be from hard plastic, not rubber....

finger sander
thingiverse

cut a strip of sandpaper as wide as the finger_sander but with double the length of the same and apply it to the tool. no print support . brim o raft required. ...depending on the accuracy of your printer, it may be necessary to remove with a cutter the...

finger_sander
prusaprinters

cut a strip of sandpaper as wide as the finger_sander but with double the length of the same and apply it to the tool. no print support . brim o raft required. ...depending on the accuracy of your printer, it may be necessary to remove with a cutter the...

Bow Sander
prusaprinters

I needed a Bow Sander to help smooth out the slot of one of my prints. I came up with this guy to do to trick.</p> <p>Takes a ~12mm wide strip of sand paper and stretches it across the curved bow. ...Ends are held in place by removable, snap-in...

Palm Sander
cults3d

This design of mine eliminates the need of special non-3d printed clamp to hold the sandpaper in place firmly Sandpaper size for this palm sander You fold 3-4 times of that sandpaper sheet, and tear it off from the crease slowly. About the stl...

Flexible sander
thingiverse

This is a flexible sander that can use basically any grit of sandpaper as long as it can bend enough to fit in the slots that hold the paper in. This is designed so you can use a piece that is 20*80mm and no more than .5mm thick. I have tested it...