lt tsurumi 3d models

And symetricaly on the other side.The second bar will be mounted the same way except the part into the silica gel box baseIllustration on the following picture :<Pic> Assemble the spooler (see bellow). Position it inside the box to mark...

I also plan to add claws and a tail holder later.This head was designed specifically for smaller printers, with a minimum build area of 18cm x 18cm x 18cm and to use comparatively little filament (<200g), while still holding up against accidental...

I found a lot of inspiration and I have remixed a lot of designs that I found online, but at the same time I designed a large portion of models, so I will try to provide as much references as possible in this description. My main goal with this...

If you do this, you'll probably have to break the groove free with a knife later, which isn't that bad as long as your printer is okay.Or you can cut the tape a little longer than needed (<height/3) and insert the excess tape into the groove. I...

Für einen besseren Längenausgleich ist die zuletzt eingesetze Schraube unter der Rolle!Auf länge PrüfenZusamm steckenNochmals PrüfenNach dem zusammen Stecken solltet Ihr ein Maß von 306mm haben.Anschlag <-> Anschlag des SchlittensDies sollte...

This tool will help you make a more efficient use of your material, and since it is non-MMU multicolor enabled and lightweight, can also help you give a good use to those leftovers in your spools! For instance, the smallest card-like version of...