lasko fan feet 3d models

Fan guard with feet for holding a 120 mm fan upright. requires self tapping PC case fan screws like in the picture. remix of: https://www.thingiverse.com/thing:1062368 Print Settings Rafts: No Supports: NoResolution: 0.2 Infill: 20 Filament: Any...

Wanhao Duplicator 6 / Monoprice Maker Ultimate Dual Motherboard Fan Holder (60mm Fans) with extended feet (5, 8, or 10mm) to clear the blue relay. An iteration on a design by mentalbob and enhanced by PIYIRIO. I employ the extended feet here and...

This thing is an addition to the "CR-6 SE Motherboard and PSU Cover Set for 80mm Fan" thing from FingersKFF, as seen here: https://www.thingiverse.com/thing:4716529 For the conversion to the extremely quiet fans from Noctua on your Creality CR-6 SE,...

After some thought, I decided to try designing my own with feet and an internally housed fan. So here it is. There are no holes for the fan screws intentionally, as the positions might be slightly off. Make your own holes to fit your fan best. This...

Customized version of http://www.thingiverse.com/thing:74322 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=74322 Instructions Using the following settings: Layer Height: 0.2 mm Text Reversal: No Picture...

... remote control holder, intended to be affixed to the side of the heater using a couple of 3M Command Strips. ... The Lasko AW300 is a nice space heater, but there's no place to stash the remote control, and so it gets misplaced on a cluttered table.

Hey there, so I found myself twiddling my thumbs while waiting for Solidworks to get installed, so I decided to whip up a quick pair of feet in Sketchup – it ended up being super useful as the electronics and especially that stepper motor can get...

After discovering a slim case that met my initial requirements, I realized it lacked a mounting solution for the fan. Undeterred, I decided to modify it myself! My Pi is used to run Octoprint. To attach the fan, simply superglue it in place with a...

Scaled up from the original.

I've included a protective fan cover and case that safeguards the rubber feet against being pushed out by the fan grill's pressure, ensuring they remain securely in place. ...Additionally, I've incorporated a minimal spacer to prevent any potential...

For assembly, print two left feet (feetwithfeetL) and two right feet (feetwithfeetR), plus four y-bar-clamps...

Just my design of a remix https://www.thingiverse.com/thing:3864094 a remix without the grid and without the closing edge SCAL IT DOWN TO 10%! ... and 8cm simple feet for mountings 120mm fan

Original thing was too wide for filterete filters. ...Also shortened the holder part where you need to put double sided tape.

OpenFlexure_feet

Feet Bones

PC feet

Troll Feet

Stepladder feet.

Feet Bones

I'm not sure what you're trying to accomplish. ...Can you provide more information about your request?

Human-Crafted Model Based on Thingiverse Design #133050 Modified with Customizer! ... View Original Project at https://www.thingiverse.com/apps/customizer/run?thing_id=133050 Customize Settings Set Up Your Design Opt...

This object was made in Tinkercad. ...Edit it online https://www.tinkercad.com/things/8sqbz2g4WuW

No information is available about this entity.

They're adding another foot to the box.