kurt d675 vise

Valentine sculpture
prusaprinters

Could be there was an upload error - so if a name listed below is missing, let me know.Aaron, Abigail, Adam, Adela, Adrian, Adrien, Agathe, Alan, Albert, Alden, Ales, Alex, Alexander, Alexandra, Alexandre, Alexia, Alexis, Alfred, Alice, Alicia,...

Customizable text buttons
prusaprinters

The names are included here so people using this site find this print and the STL when searching for their name.Aaron, Abigail, Adam, Adela, Adrian, Adrien, Agathe, Alan, Albert, Ales, Alex, Alexander, Alexandra, Alexandre, Alexia, Alexis, Alfred,...

Dell 7750 Docking Station Fix
prusaprinters

Thanks to [https://github.com/Irev-Dev](Kurt Hutten) for the tip to investigate CadQuery. Thanks to the CadQuery development team and for the support on the [CadQuery Group](https://groups.google.com/g/cadquery/c/qyUJNKCnPu4). Special thanks to to...

Experiment - Improving Magnet Clamping Force - Pot Magnet/Mounting Magnet
prusaprinters

I did this by clamping two steel washers in a vise, back to back (first marking one washer with the desired final width), and sawing off a section with a hacksaw. I then used a hand file to file the washers to my previously marked 10mm width line. I...

1:64 Chryslus Cherry Bomb (Rocket 69)
prusaprinters

Interior painted by hand with a tiny paintbrush.Base:Filed off support marks and chased out the holes (redrilled them) with a pin vise and ~1.16mm drill (no idea what it was supposed to be, found it laying around in rotary tool...

WeMos D1 Mini ESP8266 LED Bar Case
prusaprinters

I also brushed cement on the front lips of the body and the mating surfaces inside the lens and pressed the lens on.rnrnI bound the parts together using zip ties and a vise and let the cement set for about 30 minutes.rnrnThe vise I used is a Panavise...

SharkByte RunCam Camera Body for CaddX 1.66mm M12 Lens
thingiverse

I use a #66 orifice drill (0.033in) in a pin vise to pilot the board mounting holes and retainer holes, using the cover and the board to make sure the center holes are accurate as possible. To tap the camera mounting holes (there are 3 each side, you...

QRP Reel Antenna for 20M
thingiverse

##Stakes The stakes are made simply by cutting 2 6in lengths of 3/16in rod, clamping the last 1/2in in a vise, and bending to approximately a 90 degree angle. ##Antenna 1. Push the panel mount BNC connector through the large hole in the antenna...

3DP linear bearing (recirculating) and DIY linear rail 4.5mm bb (Final version)
thingiverse

Size vise linear bearing isn't much bigger than 3mm version. can be made to fit 10x10+15x2 mm linear rail. Size vise easy to print and clean up. Many options for bb's. Aluminium vs anodized aluminum anodized aluminum should be used with steel bb...

BOT Spinner
thingiverse

You might need a vise or clamp to get the ball bearings to "snap" into place if sized correctly. They should then be freely rotatable. You can order bags of 10 to 100 from Amazon or Ebay. Search for slingshot ammo. How I Designed This I designed this...