ka bar bk7 3d models

It has a cup on each end of a 124mm bar. I'd recommend mounting that either on a gridfinity baseplate where it uses up the span of four consecutive spaces (1x4), but you only need a 1x1 Gridfinity Tentacle Base each side. There would be two open...

With the rotor sitting so high above the mouthpiece, perhaps the air that is getting chopped is really between the rotor and the bar that goes across the center of the horn... The next step will be to raise the mouthpiece cone up by 1mm and...

Very interesting material, but of course it's still a fruit in processing...Probably many can note that you need to use a metal bar, but here I used carbon fiber. It was also necessary to check how much it is possible in application. And I came to...