isometric room drawing 3d models

Try to print in warm room if possible or enclosure.  I did neither and did have about a 2mm warping on the lower left corner on all but the part was still fine as it didn't impact the screw hole locations. Dont worry if it warps as all of mine did. )...

I haven't test this yet, so I don't know if the flower part is printable; I generated the gcode (with support) and it seems so. I could not find any artwork of the book, a fan art nor even a drawing of them, so this is comes out entirely from my...

I used GIMP instead of Paint.net for drawing the topography; Octave instead of MATLAB for plotting the 3D model; MeshLab for simplifying the meshes, instead of Microsoft 3D Builder; Freecad2 instead of SolidWorks for the tunnel and the World Engine;...

The blue type also take up too much room.No solder on the wires going into screw terminals. Solder will deform over time and come loose. Use bare wires or ferrules.</li></ul></td></tr></tbody></table></figure><p>&nbsp;</p><h4>10v+ 1000µF...