involute and cycloidal gear profile 3d models

http://www.thingiverse.com/apps/customizer/run?thing_id=41246 \n Customized version of https://www.thingiverse.com/thing:41246 Instructions Using the following options: 10_bore_diameter = 30 01_number_of_teeth = 28 02_circular_pitch = 800 13_twist =...

To create this custom gear, the following options were chosen: 0 teeth, 1000 outside circular pitch, 15/15 number of teeth, 20 face width, 15 gear thickness, 45 pressure angle, 13.5 bore diameter, and a 100 clearance with a 100 cone distance and no...

Roots blower [Pump] - Profile of Two lobed cycloidal rotor. ...Autodesk Inventor 2017.

Roots blower [Pump] - Profile of Two lobed cycloidal rotor. ...Autodesk Inventor 2017.

If $fn is not set, it will be 5. Parametric Involute Profile Bevel (Conical) Gears take the following parameters: number_of_teeth cone_distance: The distance from the pitch apex to the outside pitch diameter. face_width: The length of the teeth....

A Customized Version of a Complex Mechanism Crafted with Expertise: Created by http://www.thingiverse.com/thing:41435 Building Instructions Below Using Advanced Parameters: 06_Clipper_Clearance_Setting = .2 09_Retracting_Device_Position = 0...

It was produced with a variety of settings: These options were used to make it: Number of teeth: Thirty Circular pitch: Four Hundred Twist: Zero point one three Hub thickness: Ten millimeters Bore diameter: Ten millimeters Rim width: Five millimeters...

Cycloidal gears dominate motion control applications where high gear ratios of over 100:1 are necessary, accompanied by minimal friction levels.

Gears are cool!I'd seen a few axis visualisers and such like in the shape of “gears”, but most of them were artists impressions of gears (rectangles or trapeziums stuck on the outside of a circle) rather than proper involute (or cycloidal) form gears...