hydraulic hose brackets 3d models

S4 Avant Lighted LogoThis was a design I created as a retirement gift one of my best friends (lovingly nick named The Douche, no seriously, lovingly).  He had recently purchased an S4 Avant so I found this to be a fitting tribute to the...

Those sheets are: Bottom-Corners.stl Door-Knob-(x3)-and-Cable-Clips-(x10).stl Top-Corners.stl Top-Extenders.stl Additional parts that are not ganged up on a sheet with others: BIQU-B1-ac-heater-wire-redirect-strain-relief-bracket.stl (The main reason...

In “Object Mode“ (top-left drop-down) > Object > Set Origin > Geometry to Origin.Helpers_Table_Corner.STL1 x Corner screw predrill helper (3mm drill)1 x Corner leg end alignment helper1 x Corner leg holder alignment helperHelpers_Leg_Ends.STL1 x Leg...

Those sheets are: **Bottom-Corners.stl** **Door-Knob-(x3)-and-Cable-Clips-(x10).stl** **Top-Corners.stl** **Top-Extenders.stl** Additional parts that are not ganged up on a sheet with others:...

This part is not designed by myself, but I did change it to meet accurate dimensional requirements.electronics bay print bottom on the plate with supports so the cavities for the nuts are nice and clean.Supports on build plate should be enoughfront...

Power cut-off switch has been added.-Control panel redesigned to add a led switch and battery status monitor.-Added a led light bracket. .3mf files now have the proper print profile, such as ideal part position, layer height, fill and manual...

However my analysis and testing shows a carefully designed 3D printed solution is actually better:All force is are supported within 2cm by steel bolts through to the aluminum bracket.Force is held on both sides of the bearings, no just one.Any force...

With the new job as a driving force I finally got this to a working prototype. I solved the gap with the smooth rods by making some Z-rod compensator brackets. They seem to do the job ok. Included is a video of the printer making a 20mm calibration...

So I fired up Fusion 360, grabbed my shelf-clip bracket (which fits great on my 25mm thick desk/hutch top), and created a new project: the one-piece Bose QC35 Headphone Holder. I fiddled with geometry and fillets to get things to look nice and fit...

Those sheets are: • Bottom Corners and Back Bushings.stl • Top-Corners.stl • Top-Extenders.stl • Door-Knob-(x3)-and-Cable-Clips-(x10).stl Additional parts that are not ganged up on a sheet with others: •...

Those sheets are:• Bottom Corners and Back Bushings.stl• Top-Corners.stl• Top-Extenders.stl• Door-Knob-(x3)-and-Cable-Clips-(x10).stlAdditional parts that are not ganged up on a sheet with others:•...