htd pulley generator 3d models
152160 3d models found related to htd pulley generator.
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the Following Options: Shaft Distance for Nut Equals 3.5 Millimeters Retainer Selected is 1 Piece Teeth Height of Pulley Measures 8 Millimeters Number of Teeth on Gear...
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the Following Options: Shaft Height for Retainer HT = 1.5 Bearing Height for Pulley B = 8 Diameter for Bearing B = 10 Height for Idler = 1.5 Number of Idlers = 1...
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the following settings: Motor Shaft: 3 mm M3 Nut Hexagon Diameter: 1 Additional Tooth Width: 0.2 mm Profile: 10 degrees Nut Angle: 90 degrees Pulley Backing Dia: 20 mm...
thingiverse
Belt pulley bottom diameter is set to 40 mm. Retainer height is a mere 2 mm. Three nuts are required for this design. Pulley bottom height is a measured 8 mm. Additional tooth width has been increased by 0.2 mm. M3 nut flats measure 5.7 mm. The...
thingiverse
Belt pulley bottom diameter reads 5 ohms in metric units. Motor shaft size matches fifty standard gauge width in metric. Retainer depth matches forty five standard gauge widths in metric. Nut angle set to precise ninety degrees. Total number of nut...