hose clamp fastener 3d models
106605 3d models found related to hose clamp fastener.
thingiverse
Customized version of https://www.thingiverse.com/thing:811108 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=811108
thingiverse
Customized version of https://www.thingiverse.com/thing:811108 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=811108
thingiverse
Customized version of https://www.thingiverse.com/thing:811108 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=811108
thingiverse
Broke the clip on my Nilfisk vacuume, so I designed a new one that clicked in place. It's a bit tight, but snaps in place. ... Printing: Place the clip upsite down (I used "place on face" i PrusaSlicer), and print with a brim.
thingiverse
Remixed to fit a 14mm (silicone) tube or smaller. Used a M16 thread, the screw is already scaled to 99% in X/Y for smooth movement. Used a high output resolution. Included the .f3d files. ...
thingiverse
Henry's been busted, so this tweak gets him back in working order. Main threads operate smoothly at M61 x 5, though manufacturers can be stubborn with specialty threads; maybe it's M62 instead. This setup works just fine on my rig. Link to OnShape:...
thingiverse
I just had to tinker with the layout. The diameter is roughly 29 millimeters. I went ahead and printed it without any raft or support structures, and the initial layer thickness came out to be about .8 mm... ...You may need a utility knife or an Allen...
thingiverse
Customized version of https://www.thingiverse.com/thing:4435747 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=4435747
thingiverse
We're putting it to use on whirlpools as a puncture-fighting solution with a big smile. ...First, we place the rear section face down, and then simply push the front part upwards from directly above.
thingiverse
Customized version of https://www.thingiverse.com/thing:4353775 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=4353775
thingiverse
Customized version of https://www.thingiverse.com/thing:2740125 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=2740125
thingiverse
This object was made in Tinkercad. ...Edit it online https://www.tinkercad.com/things/bLjFZcRyK11
thingiverse
This object was made in Tinkercad. ...Edit it online https://www.tinkercad.com/things/bLjFZcRyK11
prusaprinters
I couldn't help but play with the design. Size is 29 mm approx. I printed with no raft or supports, and first layer size was .8.........You might need to use a knife or small screw driver to separate the teeth. ... Category: Parts
thingiverse
This object was made in Tinkercad. ...Edit it online https://www.tinkercad.com/things/bLjFZcRyK11
thingiverse
This object was made in Tinkercad. ...Edit it online https://www.tinkercad.com/things/bLjFZcRyK11