hollow knight blacksmith location 3d models

The Battle Island was a small, remote island located in the Pacific Ocean that would play host to one of the most brutal battles of World War II. The Japanese army had occupied the island for over two years, using it as a strategic base from which...

I adjusted the cut length to give a curve when the Molex connector was assembled into where the cable chain connector would be located. I reused the stock wire cut off from the temperature sensor in the Molex connector so I would not need to crimp...

UPDATE (Jan 2022) on **DRY BOX OR SPOOL HOLDER** ------------------------------------------------------------------------------------------- For quite a while, I had no issues with feeding the filament straight from my dry boxes, which are located...

 I did neither and did have about a 2mm warping on the lower left corner on all but the part was still fine as it didn't impact the screw hole locations. Dont worry if it warps as all of mine did.  Print with no priming loops so it fits, and no...

I was able to avoid this issue by changing the location of the print on my print bed (which says more about the evenness of heating in my bed than anything else). Also, be sure to keep the “elephants foot” issue in mind. It should not be a big issue,...

Filament Spool StandWith the advent of a new printer, which I assembled last summer, the question arose about the location of the coil. The standard place of the coil is behind the printer, but this gave me of inconveniences with access. And since my...

Find more details at http://shapedo.com/telepath/atomic_cat_food_ball. assistant I initially used mirks Cat Food Ball, but my cat kept leaving it in inconvenient locations. To enhance its stability, I designed a one-piece Atomic Cat Food Ball with a...

Line up the bearings below the carriage until you feel the location is correct then press down, use both hands if needed, it is a good idea to hold the rods as well so they don't bend down. It will sit firmly and will snap over the bearings. Once...

Line up the bearings below the carriage until you feel the location is correct then press down, use both hands if needed, it is a good idea to hold the rods as well so they don't bend down. It will sit firmly and will snap over the bearings. Once...

The two halves self locate.If you do decide to print the large parts, keep in mind that they us A LOT of filament. Also, the gas struts can exert a lot of force and, for some components, that can lead to layer delamination due to the print...

Line up the bearings below the carriage until you feel the location is correct then press down, use both hands if needed, it is a good idea to hold the rods as well so they don't bend down. It will sit firmly and will snap over the bearings. Once...

Line up the bearings below the carriage until you feel the location is correct then press down, use both hands if needed, it is a good idea to hold the rods as well so they don't bend down. It will sit firmly and will snap over the bearings. Once...

Line up the bearings below the carriage until you feel the location is correct then press down, use both hands if needed, it is a good idea to hold the rods as well so they don't bend down. It will sit firmly and will snap over the bearings. Once...

Line up the bearings below the carriage until you feel the location is correct then press down, use both hands if needed, it is a good idea to hold the rods as well so they don't bend down. It will sit firmly and will snap over the bearings. Once...

Line up the bearings below the carriage until you feel the location is correct then press down, use both hands if needed, it is a good idea to hold the rods as well so they don't bend down. It will sit firmly and will snap over the bearings. Once...

Line up the bearings below the carriage until you feel the location is correct then press down, use both hands if needed, it is a good idea to hold the rods as well so they don't bend down. It will sit firmly and will snap over the bearings. Once...