hob knobs 3d models

I noticed that the unit appears to run constantly so I decided to compare the inside temps using the temp control knob. I found that the temp settings on the device made no difference and that it was always running around 65 degrees C. It appeared...

C and D must be removable of course.Optional: Tension wheelParts:Respool_Tensionwheel1.stp/stl, 3 partsM5x30 bolt with Hex-head (A)M5x20 bolt (B)M5 wingnut or a knob whit nut2 woodscrewsV-slot wheel (like on most printers today)This part gives some...

Inserts should be flush or sit below the surface of the part, none should stick out from the parts. I included some "dots" than can be taped or glued on the bottom after printing, these are designed to fit the bottom of the Stanley case, but are not...

Those sheets are: **Bottom-Corners.stl** **Door-Knob-(x3)-and-Cable-Clips-(x10).stl** **Top-Corners.stl** **Top-Extenders.stl** Additional parts that are not ganged up on a sheet with others:...

# Index 1 = display, Index 2 and 3 = Knob #[delayed_gcode setdisplayneopixel] #initial_duration: 1 #gcode: # SET_LED LED=fysetc_mini12864 RED=0.3 GREEN=0.3 BLUE=0.3 INDEX=1 TRANSMIT=0 # SET_LED LED=fysetc_mini12864 RED=0.3 GREEN=0.3 BLUE=0.3 INDEX=2...

Those sheets are: • Bottom Corners and Back Bushings.stl • Top-Corners.stl • Top-Extenders.stl • Door-Knob-(x3)-and-Cable-Clips-(x10).stl Additional parts that are not ganged up on a sheet with others: •...

Super easy customizer for creating bolts, nuts, washers, threaded rods, and standoffs.Features:easier than other thread customizers, just pick a thread and configure details950 threadsfive types of bolt heads : standard, cheese, countersunk, round,...

Those sheets are:• Bottom Corners and Back Bushings.stl• Top-Corners.stl• Top-Extenders.stl• Door-Knob-(x3)-and-Cable-Clips-(x10).stlAdditional parts that are not ganged up on a sheet with others:•...

If enabled and when printing from TFT SD / TFT U Disk, during heating the TFT periodically sets the printer's (neopixel) LED color and TFT's knob LED color, if any, according to the current nozzle and bed temperatures. * Configurable suppression...

If enabled and when printing from TFT SD / TFT U Disk, during heating the TFT periodically sets the printer's (neopixel) LED color and TFT's knob LED color, if any, according to the current nozzle and bed temperatures. - Configurable suppression...