hex blade warlock 3d models

Looking at the failed print I had the idea to use single or dual layer prints as sails or blades for a DIY 3D-printed wind wheel. So after a few days of planning, designing and a little bit of trial and error, this is the design I came up...

Install the grip with two M4x16mm screws (do not forget to insert M4 Hex nuts into the back part of the grip).         [red] thin wall must be oriented to the longer side of the glass panel.[green] Inside...

Add missing Hex screw at back of Jaw. 6. Enhance details on Arc Rail Flashlight so that they stand out better on printed parts. 7. (UNDECIDED) Finish modeling the straps and cloth as 3D printable parts that go across the skullcap for those who...

To use my Marlin FW on Genius or to change some settings for Sidewinder X1: * install MS vscode compiler on PC / laptop * install the extension PlatformIO IDE 2.3.2 or above on vscode * open the FW source project with vscode: * set the following...

Flash on the printer the created fw file `Marlin-2.0.x\.pio\build\mega2560\firmware.hex` ## Integration with OctoPrint The serial bus with the mainboard **MKS GEN L v1.0** is shared between TFT and OctoPrint / ESP3D / Pronterface etc. This means...

In this tale, Rostam is still an adolescent and kills a dragon in the "Orient" (either India or China depending on the source) by forcing it to swallow either ox hides filled with quicklime and stones or poisoned blades. The dragon swallows these...