herome 3d models

... a screw in that case). The fan shroud is a remix of the HeroMe fan shroud - https://www.thingiverse.com/thing:4460970 -, shrunk in the Y direction (the original is too big and makes the hotend carriage crash into the frame of the Ender 5). ...

This is a remix of the HeroMe LED bar for the 5015 dual fan. I am using the separate 5020 dual fans with the Hero Me base. I already had an existing LED setup mounted on the top of the frame for my Ender 3. But I felt I needed an additional LED...

... Credits (important): Credits to mediaman (Hero Me Gen5 Master Suite – 4460970), Dimide (Ender 5 Hero Me Gen 5 no Y offset for BL Touch and OEM – 4591031) and theFPVgeek (HeroMe Ender3 Sherpa Mini Mount – 4687721). Thank you for all your nice works.

No additional part from the original HeroMe Gen 5 package is required. Additional (not printed) parts needed to install this cooling system: - 1x 4010 fan 24v (identical to the original one) - 4x M3 nuts - 1x M3 8mm - 1x M3 8mm flat head - 2x M2 12mm...

I also use the HeroMe Gen5 with dual radial fans and never cool at more than 70%. For greatest level of strength and reliability, I orient these clips on their side when preparing to slice. This allows for layers to be built in such a way that the...

Note the HeroME (as seen in the images) does not fit as a standard part. I had to remove the cable guide and also the part of the base which hooks around the right hand side of the hotend mounting plate to get it to fit. ... I will be changing to the...

1 x HotEnd Fan Cage, v2 (ABS!!!, print flat, RE picture, no support) borrowed and re-mastered from HeroMe at: https://www.thingiverse.com/thing:3092044 2 x M3x8 (mount to HotEnd Plate) 2 x M2.4 screws (mount to HotEnd Plate, on its top) 2 x M3x20...

This one isn't bad compared to most others I have used, but not as good as the HeroMe.  I did lose Z height with the Hero Me. This setup is actually higher than stock one by a few mm, so gained a little z-height.  It also clears the X axis...

I designed this because a hex-stud thermistor I bought did not clear the stock fan shroud, and while I tried the "herome" shroud on thingiverse, it did not afford enough clearance for my aftermarket heatsink. It is one of the first things I've...

A water test under the duct revealed that the airflow from the HeroMe duct is directed at too sharp an angle for an E3D style nozzle and therefore it largely misses the tip of the nozzle. The bullseye duct has a far more straight flow from the duct,...

A water test under the duct showed that the airflow from the HeroMe duct is directed at too sharp an angle for an E3D style nozzle and therefore it largely misses the tip of the nozzle. The bullseye duct has a far more straight flow from the duct and...