headphone swivel part 3d models

Swivel Mount Designed to mount your Sonos Move speaker outside and swivel for multiple angle listening.

... M8 nuts, six M8 washers, and six M6 nuts. To complete this swivel arm, printing supports is necessary, specifically for the swivel arm itself. ...For optimal results, print these supports at a layer height of .3 with an infill percentage of 40%.

Support for headphones, set to 110%, if they are very large.

Swivel

Headphone

Headphone

Swivel JackSide WindWeld on mounting plate, pin through jack

Swivel / tiltableBearing / plate / base / mountLazy Susan turntableStool / boat seat245x245mmSolidworks

A relaxing swivel chair used in offices and conference rooms.

Plastic swivel wheel D125 with fixed angle of rotation

A QD swivel for my crossbow, for decoration

Offset swivel plate Autodesk Inventor Professional Student Lisence

Swivel & Angle Vise, no scales or handles included.

Offset swivel plate Autodesk Inventor Professional Student Lisence

Outer Body - Hydraulic Swivel. ... 2 off Inlets, 2 off outlets.

Swivel mandrel for mounting the transducer in a dovetail

A well-designed swivel chair boasts impressive craftsmanship.

Plastic swivel wheel D125 with fixed angle of rotation

Swivel mandrel for mounting the transducer in a dovetail

Spring attached with two Swivel at both end

2 Hole swivel tap with a stone sink

Spring with Swivel Hook render 3d design modern

Practical and simple swivel base for displaying lightweight models.

Swivel plate with lock.175 x 175 x 25 (mm)

Swivel JackSide WindWeld on mounting plate, pin through jack

A swiveling attachment enables the connected item to rotate effortlessly.

swivel chair designA little exercise, hope you like it

Swivel plate with lock.175 x 175 x 25 (mm)

My church has two broken mic stand swivels, but I couldn't find a replacement part to order and it just seems wasteful to order new mic stands. So I grabbed my calipers out and started measuring. After a few hours in OpenSCAD, I was able to model a...

... extended the arm a bit so it will line up better with the direct drive. There is a 4mm hold in the swivel to add a short piece of PTFE tube to prevent ware on the swivel from the filament. ... Parts needed: M4x16 bolt M4 "T" nut 8mm of PTFE tube