hd6xx modmic 3d models

Sticks out 70mm from wall, far enough for large headsets like Sennheiser HD6XX. Uses a single 3.5mm diameter screw which is on the inside of the shape so that it's not visible. It is countersunk. Simply drill a hole, use a rawl plug and one 3.5mm...

Dust cover for the Drop Sennheiser HD58x Jubilee and Drop Sennheider HD6xx.If you have slightly smaller or larger pads/cushions  but with the same shape, you can simply adjust the size in you slicer. ...The cover was measured with new and light...

I made this to mount to my wall by my bed to hold my Schiit Vali headphone amp that I pair with some HD6XX headphones for nightime listening. I'm no designer, at all. I tried to integrate pass through holes for the power and RCA cables in the...

Should work with HD6xx, HD650, HD600, HD58x, HD580, HD660S, HD565, HD545 Depicted in the photo is an HD58x with Shure SRH1540 Alcantara Ear Pads. If you remove the stock foam and use the included foam on the Shure ear pads you get a very similar...

Cable clip for Modmic v2 (1.5mm cable). Designed to work seamlessly with headphones featuring a 3.5mm cable, such as the Sennheiser HD 598 model. Print Settings: Printer: MP Select Mini Rafts: No rafts are needed in this print. Supports: The...

The original Makerbot headphone stand has steep overhangs that tend to warp due to heat, it's not symmetrical, the headband rest is too narrow and doesn't fit the band of the HD6XX, etc. This new print is much easier and produces better results for...

I made this to mount to my wall by my bed to hold my Schiit Vali headphone amp that I pair with some HD6XX headphones for nightime listening. I'm no designer, at all. I tried to integrate pass through holes for the power and RCA cables in the back. I...

I wanted a custom fitted stand for my (absolutely wonderful) HD6XX headphones. I borrowed heavily from the Makerbot headphone stand, but took the opportunity to remodel everything from scratch and address some of the nagging issues that I had with...

The back is based on the Sposhal Hd6xx Hd58x Jubilee Closed Back, i enlarged it for the Tesla II driver on open with grid, i add a piece of wool felt. I create the Tesla II adapter from scratch. The Tesla II driver : Features: Tesla II...

I wanted a custom-made stand for my (absolutely wonderful) HD6XX headphones, so I borrowed heavily from the Makerbot headphone stand but took the opportunity to remodel everything from scratch. This allowed me to address some of the nagging issues...

This is based on the: Quest 2 Headphone Adapter (Sony ZX110) https://www.thingiverse.com/thing:4632334 by SolidRye to mount the: Sony MDR-ZX110 or MDR-ZX310 Headphones to the: GearHead Strap for Quest 2 https://www.thingiverse.com/thing:4815973 by...

This is based on the:Quest 2 Headphone Adapter (Sony ZX110)by SolidRyeto mount the:Sony MDR-ZX110 or MDR-ZX310 Headphonesto the:GearHead Strap for Quest 2by AdamAndEvilIt slides in the side "Rail" of the headstrap so they can move back and forwards...

There are other ways to go about doing this like using an Antlion ModMic (good reviews but I have no personal experience with it), an in-line volume control, a Y-adapter, and the audio cable that comes with your headphones. Cost aside, I hate the...