half orc female monk 3d models

This happens every time the Z-axis shafts stop rotating after two and a half seconds. And do not worry about the memory resource (read / write), although the Arduino claims one hundred thousand cycles, but I implemented this process in such a way...

2021/9/30: The forehead half model was missing its details. I have corrected this. Additionally, I split the original 'MCOR Helmet Skull Cap.stl' file up so that the dome portion is now separate from the side panel. This makes this piece easier to...

Apparently the rotor stops in a position where it has, so to speak, a half-dead magnetic field (I think so, maybe I’m wrong) ... But in principle it works ... But sometimes you have to start by turning the rotor, and this is inconvenient, of course,...

But what do you do when the dispenser keeps tipping over if it has less than half the amount of alcohol left? These thoughts have been occupying my mind lately. Additionally, I noticed lock boxes and decided to try printing one using a borrowed...

mostly black or white, plus orange for one half of the filament release. So, it kinda bore a vague resemblance to the bird, if you squint at it just right. Plus, I'm also a strong supporter of open source software, especially on Linux. Since that OS...

Attach the belt to the belt clip in the upper half of the printed carriage, then run it up and over the idler pulley at the endstop holder, then back down through the left side of the carriage, around the motor pulley, then back to the printed...