gyroscope 3d

Replacement for RC helicopter rotors Inner ring diameter: 2,1mm length beween ring centres: 9mm The design relies on the first layer being slightly wider than rest of the print.

IN THIS MODEL WE HAD CREATE SUCH TYPE OF VEHICLE WHICH CAN BE BALANCE BY ITS OWN

I optimized the original for **beer cans** which have a diameter of **67mm**. **The nut holders are for 7mm M4 nuts** (the original used a bigger not so common nut size). It still uses **M4 x 18mm** screws just like the original. I did not...

A colleague designed a Holder for the GY-91 Board for me. Here is the .STL. ATTENTION: Please measure the Holes! ...I am not sure if they are correct in this Version!

<p>I optimized the original for <strong>beer cans</strong> which have a diameter of <strong>67mm</strong>.</p><p><strong>I changed the nut size for the center holder to 7mm M4 nuts</strong> (the original used a bigger not so common nut...

I love the original MEMS gyro, but it wasn't the right size of a wallet. Plus I found that the 0.5mm thin wall joints of vertical joints to be hard to print without gaps. So I used the 1mm joints throughout. ...Additionally I scaled it down vertically...

Customized version of https://www.thingiverse.com/thing:1675026 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=1675026

Replacement for RC helicopter rotors Inner ring diameter: 2,1mm length beween ring centres: 9mm The design relies on the first layer being slightly wider than rest of the print.