govee camera 3d models
118013 3d models found related to govee camera.
prusaprinters
This mount gives you a flat surface to mount a Govee light in the top center of a gable roof peak. I designed it to perfectly fit a roof with a pitch around 5.3/12 with the arctan(5.3/12) = 23.83 degrees. It should work fine for roofs with a similar...
prusaprinters
Please consider clicking the ❤ and/or leaving me an encouraging comment if you appreciate my effort. If you print this model, please take a picture of your awesome new Govee RGBIC LED Permanent Outdoor Lighting Mounting Brackets in action. Then, post...
thingiverse
Remixed from AZRUGDOC for a sealed version to hide the light in certain areas.
thingiverse
Customized version of https://www.thingiverse.com/thing:3204763 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=3204763
prusaprinters
The double sided tape doesn't hold up to the weather conditions where I live, so designed/remixed a mount to keep the RGBIC lights and connectors properly mounted. There are 4 variants:LED mount with 2 screwsLED mount with 1 screw and thin profileLED...
thingiverse
I bought a light strip on Amazon and didn't have a good place to put the remote. I designed this to be stuck on a surface with double sided tape. If you want the fusion file, I can provide it. My printer wasn't dialed when I printed this but it...
thingiverse
Remixed to allow this clip to be mounted using a Ryobi power nailer vs. the screws. ... Makes for a much faster install while standing on a ladder (see my installation video on YouTube)https://youtu.be/4n8xZY3wnK4I made the slot a bit wider for a loose...
thingiverse
Had a few lights above a lower roof that needed to be angled out so I built this in Fusion 360, with heavy inspiration taken from the 30degree angle mount found here on thingiverse.Doesn't need supports.
thingiverse
Print without support in 0,2 mm layer heigth with max cooling.
thingiverse
this is a camera rig for the camera module of a plexgear camera, the original camera is too big and it could use a smaller rig to be used in the printer
thingiverse
This camera system enables users to install two cameras stacked vertically, securely fastened by a standard BSP 1/4 threaded connection.
myminifactory
This is a DIY Camera Tripod / Camera Statief. To assemble it, you'll need several key components. These include all the 3D-printed parts, as well as a Satay Stick and an M5 Bolt. You will also require an M5 Nut. This tripod was designed specifically...
prusaprinters
The camera mount model was designed in Fusion 360 and sliced using PrusaSlicer.It was printed on my Prusa MK3s+I have included all the files.I did not glue the top platform or the ribbon cable restraint as they did not require glue but you certainly...
grabcad
After opening the aperture to let the light in you must time the amount of exposure and then close the aperture before using a dark room to develop the photo.This was a super cool project and I had a lot of fun building and designing the camera. Most...
thingiverse
Need a dual holder for my power supplies that would would allow for easy removal in case of a failure.Here is my installation video of the lights where you can see the bracket.https://youtu.be/4n8xZY3wnK4
prusaprinters
This model has a solid side - the user can print the file with NO top or bottom layers - this will expose the infill of your choosing, thus using less filament and giving it a cool look.Recommend using a 25% Infill w/ Tri-hex infill.