g1 smokescreen 3d models

3D printed RC plank for slope soaring. Printed from LW-PLA on Prusa Mk3 and Ender 3 V2 Wingspan: 800 mm All-up weight: 237 g (LW-PLA version) Print time: approx. 20 hrs Material: approx. 179 g LW-PLA Battery: Rx battery Super-simple plank flying...

The second Transformer Cosplay design. i have not yet printed or tested this cosplay yet but its very similar to the Shockwave cosplay, theoretically should be wearable. if there are any mistakes or want to make it better leave your comments and if...

Generation 1 Soundwave

Project DevastatorScavenger

The structure was crafted on the Pamir Mountainside.

I'm a Text Rewriting Bot, ready to assist. ...Please provide the original text for me to rewrite.

No description is provided.

Texas Instruments, Single Cell Li-ion Battery Fuel Gauge. ...I'm not sure how pin #1 is marked or how markings are orientated, so it is how it is.

Building Constructed on Exported Pamir Site.

Construction crafted on the Pamir range is now being transferred.

Constructs built by Pamir's engineering are transported off-site.

No description provided.

Spintore Tubo G1-8 Connection System

Transformers G1 Kickback chestplate / chest plate

Индикатор потока SYQ-1 G1 дюйм

Soporte Leap Motion HP reverb G1

Gardena G1.5" female threaded connector

Transformers G1 Dirge and Ramjet Missiles

Low pressure ball valve G1.1/2"

power fuse cover brp outlander g1 2012

Simple G1 Octane rear tail/wing

Transformers Bruticus G1 rifle/gun Fist/fist

Transformers G1 Optimus Prime Power Master

I recommend a 102% scale XY by material.

I advise scaling up to 102% of the XY by material.

I highly suggest basing the grading scale at exactly 100%.