funtime motors 3d models

On one board both the ABL header pins and three pin pancake stepper motor (Sherpa mini) run alongside the heated bed and hot-end heater cartridge wires. My bed heater is 200W at 24V so draws up to 8.4A.</p><p>My intention is to minimise the hole...

Make sure the power jack nut is installed as the nut cannot fit over the female spade connectors.Remove the electronics case cover.Remove the two screws holding the rear printer frame to the extrusion next to the electronics case.Insert the red and...

The curve shaped like an S keeps the filament lodged firmly but gently against the walls so after a retraction it doesn't move out of position, so 2.5mm tubing is not needed and we can use a more smooth 3mm that puts less strain on the motors. The...