frieza half 3d models

This happens every time the Z-axis shafts stop rotating after two and a half seconds. And do not worry about the memory resource (read / write), although the Arduino claims one hundred thousand cycles, but I implemented this process in such a way...

Apparently the rotor stops in a position where it has, so to speak, a half-dead magnetic field (I think so, maybe I’m wrong) ... But in principle it works ... But sometimes you have to start by turning the rotor, and this is inconvenient, of course,...

Attach the belt to the belt clip in the upper half of the printed carriage, then run it up and over the idler pulley at the endstop holder, then back down through the left side of the carriage, around the motor pulley, then back to the printed...