fpv canopy 3d models
24079 3d models found related to fpv canopy.
thingiverse
I designed this canopy as a replacement for the standard foam canopy on my micro/nano skyhunter. As one of the last users still rocking an Immersion 600mw VTX, I also created a blank model that can be remixed to suit other FPV setups. ...If you're...
thingiverse
My camera equipment is mounted in and on the nose, so I didn't require this area for an FPV pod or anything else. Additionally, it enhances aerodynamics slightly compared to a pod. Given my 15x15cm printer constraints, parts had to be scaled down...
thingiverse
The standard kit comes with sleek red anodized aluminum posts that raise the canopy, but I wanted something that still secures the nose of the Peeper when closed. I utilized 15mm long M2 screws through the bottom plate, through the spacer, and...
thingiverse
Engineered to snugly accommodate the KingKong 700TVL FPV Camera, this design clears a substantial 16x16mm stack while maintaining an impressive height of up to 18.5mm. The canopy securely fastens to the toothpick mounting holes, strategically...
cults3d
Hi there, I created this custom part to fit snugly onto my Tarot Peeper quadcopter, specifically designed to lift the canopy by a precise 10mm, allowing for more space to accommodate my Pixhawk FC. The standard kit comes with sleek red anodized...
prusaprinters
I designed this canopy for Dronarchy so he could fly the DJI O3 in DLQFPV and MambaFPV ASBOX frame. Print in your favorite TPU. When you are ready to install the VTX just run some hot air over the Canopy to make it slightly more pliable and slip the...
thingiverse
... at a precise 15-degree angle, ensuring optimal low-angle shots. Check out the vtx I used in the link below: https://www.banggood.com/Eachine-TX01S-NTSC-Mini-5_8G-40CH-25MW-VTX-600TVL-13-Cmos-FPV-Camera-p-1139788.html?rmmds=search&cur_warehouse=CN
thingiverse
Suggested parts 4x M3 nut (normal nut, no lock-nut) 4x M3 10mm screw FPV Camera: HS1177 or HS1190 (or similar) FPV Lens: GoPro 2 lens VTX: ImmersionRC TrampHV or TBS Unify Pro (both with telemetry support in Betaflight) GoPro HD mount adapters The HD...
thingiverse
Made a full-size FliteTest Spitfire and wanted to fly it FPV, so I built a quick camera mount canopy thing. "Canopy Blank" is just a placeholder meant to mimic a canopy; "MK2" is a fully functional VTx + Camera + FC (for OSD) mount. Assumes a...
thingiverse
It is designed to replace the vanilla foam canopy, to increase available internal volume and be a convenient mounting point for FPV equipment. I have included files for the canopy as I used it, as well a "clean" version to make it easier for you to...